Step
1.
Enter system view.
2.
Change the state of the IRF fabric from
Recovery to Active.
After the IRF fabric is recovered, all ports that have been shut down by MAD automatically come up.
Displaying and maintaining an IRF fabric
Task
Display information about all IRF
members.
Display the IRF fabric topology.
Display basic IRF settings.
Display the master/subordinate
switchover state of IRF members.
Display MAD configuration.
Configuration examples
This section provides IRF configuration examples for IRF fabrics that use different MAD mechanisms.
LACP MAD-enabled IRF configuration example
Network requirements
Set up a two-member IRF fabric at the access layer of the enterprise network in
MAD in the IRF fabric, because the IRF fabric has a multi-chassis aggregate link to Device C, an HP
device that supports extended LACP.
Command
system-view
mad restore
Command
display irf [ | { begin | exclude |
include } regular-expression ]
display irf topology [ | { begin |
exclude | include }
regular-expression ]
display irf configuration [ | { begin
| exclude | include }
regular-expression ]
display switchover state [ slot
member-id ] [ | { begin | exclude |
include } regular-expression ]
display mad [ verbose ] [ | { begin
| exclude | include }
regular-expression ]
28
Remarks
Available in any view.
Available in any view.
Available in any view.
Available in any view.
Available in any view.
Figure
13. Configure LACP