3Com V7111 Analog Gateways - 3Com VCX V7000 Installation And Maintenance Manual

102 C 5: I
HAPTER NSTALLING
3Com V7111 Analog
Gateways
D
EVICES
8 Enter this command to set the IP address of the secondary VCX server:
vcxSetAltSrvrIP 10.20.30.42
9 If a DHCP server does not provide IP addresses on your network, enter
these commands:
To assign an IP address that you select to the Attendant Console:
nbxSetIpAddress 192.168.10.101
To define the subnetwork mask for this subnetwork:
nbxSetSubnetMask 255.255.255.0
To define the IP address for the gateway on this subnetwork:
nbxSetGatewayAddress 192.168.10.254
10 Enter this command to restart the Attendant Console:
nbxReset
The Attendant Console communicates with the primary VCX server. Use
the Administrator Interface to:
Verify that the Attendant Console has been discovered by the VCX
■
system
Perform the remaining configuration of the Attendant Console
■
Associate the Attendant Console with a particular phone
■
For instructions on how to perform these tasks, see the VCX
Administration Guide.
Configuring the 3105 Attendant Console Without a DHCP Server
V7111 Analog Gateways connect the VCX system in two directions.
FXO versions connect to analog trunk lines from the Public Switched
■
Telephone Network (PSTN).
FXS versions connect to analog telephones or fax machines.
■
There are 4-port and 8-port FXO versions of the V7111.
There are 2-port, 4-port, and 8-port FXS versions of the V7111.
To configure any V7111 analog gateway, use a browser to connect to the
gateway. Read and follow the instructions in the 3Com VCX V7111 Fast
Track Installation Guide. You can obtain a copy of this guide from the
3Com Partner Access web site.