INSTALLATION
1. Engage the front hook and push cowl back over the cowl seal.
2. Push cowl down and move the rear latch lever down to lock.
Flywheel Cover Removal and Installation
REMOVAL
1. Remove the flywheel cover by lifting off.
2. Pull out the vent hose.
INSTALLATION
1. Install flywheel cover as follows:
a. Place cover onto the front flange.
b. Push rear of the cover down onto the rear pin and air intake tube for
the air compressor.
c. Insert vent hose into the hole.
IMPORTANT: Make sure the flywheel cover is pushed down on the air intake
tube for the air compressor.
a
a -
Front flange
b -
Air intake tube
c -
Vent hose
Fuel System
Fuel is flammable and explosive. Ensure that the key switch is off and the
lanyard is positioned so that the engine cannot start. Do not smoke or allow
sources of spark or open flame in the area while servicing. Keep the work
area well ventilated and avoid prolonged exposure to vapors. Always check
for leaks before attempting to start the engine, and wipe up any spilled fuel
immediately.
eng
MAINTENANCE
c
!
WARNING
45
b
29395