Electrical Safety; Description (Fig. A); Assembly (Fig. D); Grounding Instructions - Tunturi T20 User Manual

- Keep your hair away from the moving parts.
- Wear appropriate clothing and shoes.
- Keep clothing, jewelry and other objects away from
the moving parts.
- Make sure that only one person uses the equipment
at a time. The equipment must not be used by
persons weighing more than 135 kg (300 lbs).
- Do not open equipment without consulting your
dealer.

Electrical safety

(Only for equipment with electric power)
- Before use, always check that the mains voltage is
the same as the voltage on the rating plate of the
equipment.
- Do not use an extension cable.
- Keep the mains cable away from heat, oil and sharp
edges.
- Do not alter or modify the mains cable or the mains
plug.
- Do not use the equipment if the mains cable or the
mains plug is damaged or defective. If the mains
cable or the mains plug is damaged or defective,
contact your dealer.
- Always fully unwind the mains cable.
- Do not run the mains cable underneath the
equipment. Do not run the mains cable underneath
a carpet. Do not place any objects on the mains
cable.
- Make sure that the mains cable does not hang over
the edge of a table.
- Make sure that the mains cable cannot be caught
accidentally or tripped over.
- Do not leave the equipment unattended when the
mains plug is inserted into the wall socket.
- Do not pull the mains cable to remove the mains
plug from the wall socket.
- Remove the mains plug from the wall socket when
the equipment is not in use, before assembly or
disassembly and before cleaning and maintenance.
CAUTION
• If voltage varies by ten percent (10%) or more,
the performance of your treadmill may be
affected. Such conditions are not covered under
your warranty. If you suspect the voltage is low,
contact your local power company or a licensed
electrician for proper testing.
CAUTION
• NEVER use a RCD - Residual Current Device
(U.S. ver.= GFCI) - wall outlet with this treadmill.
As with any appliance with a large motor, the
RCD/GFCI will trip often. Route the power mains
cord away from any moving part of the treadmill
including the elevation mechanism and transport
wheels.

Grounding Instructions

This product must be grounded. If the treadmill's
electrical system should malfunction or breakdown
grounding provides a path of least resistance for
electric current, reducing the risk of electric shock.
This product is equipped with a cord having an
equipment-grounding plug. The plug must be plugged
into an appropriate outlet that is properly installed
and grounded in accordance with all local codes and
ordinances.
WARNING
• Improper connection of the equipment-
grounding conductor can result in a risk of
electric shock. Check with a qualified electrician
or serviceman if you are in doubt as to whether
the product is properly grounded. Do not modify
the plug provided with the product if it will not
fit the outlet; have a proper outlet installed by a
qualified electrician.

Description (fig. A)

Your treadmill is a piece of stationary fitness equipment
used to simulate walking or running without causing
excessive pressure to the joints.
Package contents (fig. B & C)
- The package contains the parts as shown in
fig. B.
- The package contains the fasteners as shown in fig.
C. Refer to the section "Description"
NOTE
• If a part is missing, contact your dealer.

Assembly (fig. D)

WARNING
• Assemble the equipment in the given order.
• Carry and move the equipment with at least two
persons.
CAUTION
• Place the equipment on a firm, level surface.
• Place the equipment on a protective base to
prevent damage to the floor surface.
• Allow at least 100 cm of clearance around the
equipment.
• Refer to the illustrations for the correct assembly
of the equipment.
2 1
English