Appendix A Gia 63 Main Boot Block Uploading Instructions; Introduction; Determining Current Boot Block - Garmin GIA 63 Installation Manual

APPENDIX A GIA 63 MAIN BOOT BLOCK UPLOADING INSTRUCTIONS

NOTE
This appendix applies to the GIA 63 only, and does not apply to the GIA 63W or GIA 63H.
A.1 Introduction
This appendix contains instructions on how to upgrade main boot block software for the GIA 63. Boot
block version 4.01 is required for GIA Main Software Version 4.00 or later.
CAUTION
While performing this procedure ensure the aircraft is connected to and drawing power
from a power cart. A loss of power during this procedure may result in a defective GIA 63.
A.2 Determining Current Boot Block
1. Ensure the G1000 is powered off.
2. Insert the airframe specific approved software loader card (containing GIA main software version
4.00 or later) into the top slot of the PFD.
3. While holding the ENT key on the PFD, restore power to the PFD.
4. When the words
PFD, release the ENT key.
5. Press the CLR key at the "DO YOU WANT TO UPDATE SYSTEM FILED?" prompt.
6. Repeat step 3 and 4 for the MFD.
7. Restore power to all remaining G1000 LRUs.
8. On the MFD use the FMS knob to highlight 'GIA 1' on the System Status page.
190-00303-05
Rev. Y
Figure A-1. System Status Page
appear in the upper left corner of the
GIA 63 Installation Manual
Page A-1