Connecting A Vhf/Uhf Antenna And Cable Converter; Switching Between Tuner A And B - Pioneer Elite PureVision PRO 1110HD Operating Instructions Manual

Preparation

Connecting a VHF/UHF antenna and Cable Converter

VHF antenna
Cable TV
Cable Converter
• Be sure to connect the antenna or the Cable
Converter as shown above. Signal reception may
fail if not properly connected.
• Be sure that the Cable Converter output signal is
assigned to the ANTENNA/CABLE B input on the
Media Receiver.
• How to change channels when the Cable Converter
output signal is connected to the ANTENNA/CABLE
B input on the Media Receiver.
• Press ANT on the remote control unit to switch to
ANTENNA/CABLE B.
• You can view an image right after selecting the
output channel on the Cable Converter.
Switching between antenna A and B
To watch broadcasts via the two antennas, you can
select it by pressing ANT on the remote control unit.
• While watching a broadcast, press ANT to view the
image received from the other antenna.
• Pressing ANT while viewing in Dual Screen mode
(TV image and video image) with TV selected will
display the TV image of the other antenna.
• Pressing ANT while viewing Dual Screen with two TV
images displayed will not have any effect.
• Pressing ANT while viewing Dual Screen with two
video images displayed will switch the selected
screen to a TV image.
PDP-ELITE-Eng (17-27)
UHF antenna
U/V mixer
25
Media Receiver (rear)
I N I N
OUT OUT
A ANTENNA/CABLE B
When making the above connections, first
remove the coaxial cable attached before
shipment.
9/9/03, 11:44
07
25
En