Yale E5400LN Cylindrical Series Programming/Troubleshooting Instructions page 3

Code Descriptions
User 1: Master Code –
Factory default setting of 1234
Codes should be 4 to 7 digits and entered followed by [
Assigns Supervisor and Emergency Codes
Used for Programming the lock
Will not allow the controller to unlock the mechanism
User 2: Emergency Code –
Factory default setting of 4321
Codes should be 4 to 7 digits and entered followed by [
Allows the controller to unlock the mechanism
Opens the lock for the Extended User time (10 second default)
Allows for entry when the controller low battery voltage is in the "blackout" condition
Allows access when the dead bolt (mortise lock) is thrown in all conditions
Will not allow for programming the lock
User 3: Supervisor Code
Codes should be 4 to 7 digits and entered followed by [
Allows all programming of the controller except for changing the Master Code
Does not have a default code, must be programmed
Allows access to unlock the door
Allows access when low battery exists
Has the ability to "delete all users" (Code 60) and to "delete a block of users" (Code 62)
however only Standard Users positions 6-99 can/will be deleted. The master, passage
and lock-out will not be affected.
Can utilize Code 61 "delete single user" to delete the emergency, passage & lock-out
codes. Note: if Code 61 is utilized for this purpose, the functions will be completely non-
operational (no code assigned) at this point (closet door)
User 4: Lockout Code
Codes should be 4 to 7 digits and entered followed by [
Used to restrict user codes 6-99 the ability to gain access
Only the Supervisor and Emergency Codes can override the lockout
Entering the lockout code the second time will allow Users 6-99 to re-gain entry.
Successful entry of lockout mode is indicated by a long green LED with 2 short beeps
with a pause followed by another 2 short beeps
Successful exit of lockout mode is indicated by a long green LED with 2 short beeps
User 5: Passage Code
Codes should be 4 to 7 digits and entered followed by [
Used to enable or disable the passage feature
After first entry, the lock remains unlocked
After second entry, the lock remains secure second
Operates when battery is low
Can be overridden by Lockout Code
Successful entry indicated by 1 long green LED along with 3 short beeps
Successful exit indicated by 1 long green LED with 2 short beeps
Users 6-99: Normal User Code
Codes should be 2 to 7 digits and entered followed by [
Used to unlock the lock for entry
Can not be created until the default master code has been changed and the emergency
code has been programmed
Codes 1234 & 4321 can not be used
The green LED will flash once per second upon entry of a correct code
A short red flash with 3 short beeps will occur if an incorrect code is entered
An ASSA ABLOY Group brand
*
must be changed before programming can begin
*
must be changed before programming can begin
*
]
*
]
*
]
*
]
*
]
*
]
3
80-9150-8005-010 (10-12)