User Programming Commands; Program Guide - Yale E5400LN Cylindrical Series Programming/Troubleshooting Instructions

3-Change the Master Code when Master Code has been forgotten or lost
Remove inside escutcheon
# (Hold pound depressed until Yellow LED blinks continuously)
Depress the Program (PRGM) button located at the top of the
contr oller on the i n s ide
Enter Program Command Code
Enter User number
Enter New Master Code (4-7 digits)
Re-enter New Master Code (4-7 digits)
After the Master and Emergency Codes have been entered go to the User Programming
Command chart to add additional users: Supervisor, Passage, Lockout and Normal Users.

User Programming Commands

General MC#
Format
To Enter a Master Code
# MC#
(Hold)
To Enter a Emergency Code
(Hold)
# MC#
To Enter a Supervisor Code
# (Hold) MC#
To Enter a Lockout Code
# (Hold) MC#
To Enter a Passage Code
# (Hold) MC#
To Enter a Normal
User Code
(Hold)
# MC#
User Programming Commands
Delete All Users (Deletes all codes back to defaults)
(Hold)
# MC#
Delete Individual User Codes
(Hold)
# MC#
Delete Block Of Users
(Hold)
# MC#
User Setting Reset
(Resets all Programming
Commands to default)
(Hold)
# MC#
An ASSA ABLOY Group brand
51#
1 #

PROGRAM GUIDE

PCC User LOC VAL 1
51# 1# (4-7 Digits)#
51# 2# (4-7 Digits)#
51# 3# (4-7 Digits)#
51# 4# (4-7 Digits)#
51# 5# (4-7 Digits)#
51# (6-99)# (2-7 Digits)#
60# 60#
61# (6-99)#
62# 1st LOC # 2nd LOC #
72# 72#
Yellow LED Blinks
Yellow LED Blinks
Yellow LED Blinks
# Yellow LED Blinks
# Yellow LED Blinks
Green LED Blinks
VAL 2
(4-7 Digits)#
(4-7 Digits)#
(4-7 Digits)#
(4-7 Digits)#
(4-7 Digits)#
(2-7 Digits)#
These Program
Modes and User
Codes can be
programmed
with the
Supervisor Code
(SC) or the Master
Code (MC)
5
80-9150-8005-010 (10-12)