Audio Connections - Pioneer DV-K302CD Operating Instructions Manual

Audio Connections

This player features two digital (optical and coaxial) and
also analog 2 channel and 5.1 channel audio output
connection possibilities.
Digital Audio Connections:
You can enjoy the digital audio recorded on DVD discs
from both optical digital and coaxial digital output jacks.
When making digital audio connections, do not
make connections from both the coaxial and optical
digital outputs to the same component.
When a DVD recorded in Dolby Digital, DTS, or MPEG is
loaded, noise will be output if you have made
connections via the digital audio jacks to a receiver or
amplifier that cannot decode a Dolby Digital, DTS, or
MPEG digital bitstream. In this case, be sure to set the
[Digital Jack] setting in the Setup Navigator to best
reflect the type of system you are using (page 25).
Additionally, the digital audio settings can be adjusted
manually in the Setup screen Audio 1 menu (page 33).
DIGITAL OUT (Optical)
The digital signal is transmitted as light pulses through a
optical cable.
• Use to connect to an AV amplifier or receiver with
built-in Dolby Digital, DTS, or MPEG decoder.
• Use a optical cable (not supplied) to connect the digital
optical output on the player to the digital optical input
on an AV amplifier or receiver.
DIGITAL OUT
OPT.
Note
There is no digital output when using Karaoke mode.
18
AV amplifier or receiver with
built-in Dolby Digital, DTS, or
MPEG decoder
DIGITAL IN
DIGITAL OUT (Coaxial)
The digital signal is transmitted electronically through a
coaxial cable.
• Use to connect to an AV amplifier or receiver with
built-in Dolby Digital, DTS, or MPEG decoder.
• Use a coaxial cable (not supplied) to connect the
coaxial digital output on the player to the coaxial digital
input on an AV amplifier or receiver.
DIGITAL OUT
OPT.
Note
There is no digital output when using Karaoke mode.
AV amplifier or receiver with
built-in Dolby Digital, DTS, or
MPEG decoder
DIGITAL IN