The use of a substitute replacement component which does Leakage 0.5mA current Device not have the same safety characteristics as the PIONEER tester under recommended replacement one, shown in the parts list in test this Service Manual, may create shock, fire, or other hazards.
Page 3
To protect products from damages or failures during transit, the shipping mode should be set or the shipping screws should be installed before shipment. Please be sure to follow this method especially if it is specified in this manual. DV-588A-S...
7.1.5 METHOD FOR DIAGNOSING DEGRADATION OF THE LDS ON THE PICKUP ASSY ....60 7.1.6 TROUBLE SHOOTING ........................61 7.2 DISASSEMBLY ............................63 7.3 DVD DECK SECTION..........................64 7.4 IC INFORMATION............................ 68 8. PANEL FACILITIES ............................80 8.1 FRONT PANEL SECTION ........................80 8.2 DISPLAY ..............................81 8.3 REMOTE CONTROL ..........................82 DV-588A-S...
For the applying amount of lubricants or glue, follow the instructions in this manual. (In the case of no amount instructions, apply as you think it appropriate.) 2.1 PACKING SECTION "Operating Instructions" DV-588A-S...
CD2301 NOTE: Applying positions AA, AB and AC for the CLASS PART NO. PART NAME MARK grease are displayed for this section. GREASE G-478B GEM1018 Check if the correct grease is applied for each GYA1001 PN-397 position. GEM1036 ME-913A DV-588A-S...
Page 15
: POWER PORT BLOCK J7301 S VIDEO OUT J8001 AUDIO OUT CP502(14P) Cord Connector 06C32E3504 J8102 COAXIAL DIGITAL AUDIO OS8101 1/2- OPTICAL POWER PCB ASSY (A2G601A240) : POWER BLOCK CP501 : DIGITAL AUDIO BLOCK BLACK BLACK(L) AC IN WHITE(N) WHITE DV-588A-S...
3.3 DVD MT PCB (1/6) ASSY DVD MT PCB ASSY (A2G601A130) MPEG/MICON/RF-AMP BLOCK (RF) (RF) (RF) MPEG/MICON EEPROM DV-588A-S...
Page 17
: S VIDEO SIGNAL ROUTE (C ch) (R/CR) : VIDEO SIGNAL ROUTE (R/CR ch) (G/Y) : VIDEO SIGNAL ROUTE (G/Y ch) (B/CB) : VIDEO SIGNAL ROUTE (B/CB ch) : AUDIO DATA SIGNAL ROUTE (DA) : AUDIO SIGNAL ROUTE (Digital) RESET IC CP601 DV-588A-S...
DVD MT PCB ASSY (A2G601A130) MEMORY BLOCK NOTE : THE DC VOLTAGE EACH PART WAS MEASURED WITH THE DIGITAL TESTER NOTE : THIS SCHEMATIC DIAGRAM IS THE LATEST DURING PLAYBACK. AT THE TIME OF PRINTING AND SUBJECT TO CHANGE WITHOUT NOTICE DV-588A-S...
LOADER/MOTOR DRV BLOCK (RF) (RF) NOTE : THE DC VOLTAGE EACH PART WAS MEASURED WITH THE DIGITAL TESTER DURING PLAYBACK. NOTE : THIS SCHEMATIC DIAGRAM IS THE LATEST AT THE TIME OF PRINTING AND SUBJECT TO CHANGE WITHOUT NOTICE DV-588A-S...
3.6 DVD MT PCB (4/6) ASSY DVD MT PCB ASSY (A2G601A130) AUDIO JACK BLOCK CP8001 (DA) : AUDIO DATA SIGNAL ROUTE (DA) : AUDIO SIGNAL ROUTE (Digital) : AUDIO SIGNAL ROUTE (L ch) (DA) DV-588A-S...
Page 23
NOTE : THE DC VOLTAGE EACH PART WAS MEASURED WITH THE DIGITAL TESTER DURING PLAYBACK. AUDIO LPF& AUDIO LPF& AUDIO LPF& DV-588A-S...
OPERATION 2 PCB ASSY SW660 : STOP CP605 SW662 : +SKIP SW664 : - SKIP SW663 : PLAY SW665 : PAUSE OPERATION 3 PCB ASSY CP604 (A2G501ADF0) CP603 CP602 OPERATION 3 PCB ASSY SW667 : POWER B C G DV-588A-S...
Page 29
FIP DRIVER IC CP601 NOTE : THE DC VOLTAGE EACH PART WAS MEASURED WITH THE DIGITAL TESTER DURING PLAYBACK. NOTE : THIS SCHEMATIC DIAGRAM IS THE LATEST AT THE TIME OF PRINTING AND SUBJECT TO CHANGE WITHOUT NOTICE DV-588A-S...
3.10 POWER PCB (1/2) ASSY POWER PCB ASSY (A2G601A240) POWER BLOCK PHOTO COUPLER • NOTE FOR FUSE REPLACEMENT FOR CONTINUED PROTECTION AGAINST RISK OF FIRE. CAUTION - REPLACE WITH SAME TYPE AND RATINGS OF FUSE. DV-588A-S...
Page 31
6V REG (DVD MOTOR) NOTE : THE DC VOLTAGE EACH PART WAS MEASURED WITH THE DIGITAL TESTER DURING PLAYBACK. VOLTAGE DV-588A-S...
3.11 POWER PCB (2/2) ASSY POWER PCB ASSY (A2G601A240) DIGITAL AUDIO BLOCK : AUDIO SIGNAL ROUTE (L ch) (DA) : AUDIO SIGNAL ROUTE (Digital) FROM/TO POWER P.CON+D5V {1} MMZ1608R102CT DV-588A-S...
Page 33
R8123 CP8102 TP8101 C3223003 +-1% SPDIF TP8102 J8102 COAXIAL COAXIAL YLC21-3055N W802 OS8101 OPTICAL OFTG038101 (DA) INPUT D_GND CAUTION: DIGITAL TRANSISTOR CAUTION: DIGITAL TRANSISTOR NOTE : THE DC VOLTAGE EACH PART WAS MEASURED WITH THE DIGITAL TESTER DURING PLAYBACK. DV-588A-S...
P.C.Board Resistor array 3-terminal regulator LOADING MOTOR LOADING MOTOR PCB ASSY PCB ASSY (INSERTED PARTS) (CHIP MOUNTED PARTS) SIDE A SIDE B CD2302 CP2302 SW PCB ASSY M2603 LOADING MOTOR CD2301 M2602 SLED MOTOR CD2301 M2601 SPINDLE CP2303 MOTOR DV-588A-S...
• Soldering time: Within 3 seconds • Soldering combination: Sn-3.0Ag-0.5Cu • When Soldering/Removing of solder, use the draw in equipment over the Pick Up Unit to prevent the Flux smoke from it. Pick Up PCB Short circuit using a soldering iron. Fig. 1 DV-588A-S...
• After going into test mode, if you play back the disc, "DISC-NON" is displayed. • The video signal and the audio signal are outputted during the test mode. • The SKIP key and the SCAN key are effective during the test mode. TEST MODE: OFF POWER GGF1381 Test mode remote control unit DV-588A-S...
3 LD ON DVD : Press the [TEST] (A8-5E) and [1] (A8-01) keys in order, and turn on the laser diode (650n). : Press the [TEST] (A8-5E) and [4] (A8-04) keys in order, and turn on the laser diode (780n). DV-588A-S...
• Place the unit on a workstation equipped to protect against static electricity, such as conductive mat. • Soldering iron with ground wire or ceramic type is used. • A worker needs to use a ground conductive wrist strap for body. DV-588A-S...
: [NTSC] PAL system : [PAL] Automatic setting : [AUTO] Scart terminal output [SK – ∗ ∗] (Display only the WY model which can do the output setting of scart terminal.) VIDEO : [00] S-VIDEO : [01] : [02] DV-588A-S...
After you press the A.MON key while holding the ESC key pressed and then input the region number, if the number is different from that set in the unit, an error message is displayed, and the tray opens. DV-588A-S...
1 Destination indication Display it according to model information set from the FL Driver IC. 2 Region No. 3 ROM number Rom display Version. 5 SUM CHK SUM value of E2P ROM displays with four places. 6 CHIP VERSION DV-588A-S...
%%e -2 : NG 7.0e -4 : NG 3 EDC/ID error history (ID Address, EDC/ID errors, last eight errors) Note: ∗ Error of AV1 is not supported in this player. Indication plan contents Character in bold : Item name : Information display DV-588A-S...
Measure the voltage between the two ends of R2320 or R2322 on the DVDM Assy. If the voltage is 0.4 V or higher, the 780-nm LD is degraded. To OPTICAL PICKU DVD MT PCB ASSY CP2301 Front side SIDE A DV-588A-S...
DVD MT PCB Assy Check the video signal path between DVD IC (DVD MT Assy IC4002) displayed on the monitor Video circuit after DVD IC and video-out terminal (see the block diagram) (The FL display lights. The (IC4002) mechanism does not work.) DV-588A-S...
Page 62
Any kind of symptoms (no power, a failure in any of the servo, video and audio systems, etc.) may be (DVD MT Assy : IC4002) generated, because the DVD processing is performed by a single chip. 64M SDRAM No power. (DVD MT Assy : IC4005) Block noise is generated during playback. DV-588A-S...
Up PCB and DVD PCB connector. 1-4: DVD PCB (Refer to Fig. 1-4) Power PCB Remove the 4 screws 1. Remove the 4 screws 2. Remove the DVD PCB in the direction of arrow. DVD PCB Fig. 1-2 Fig. 1-4 DV-588A-S...
Page 65
3 supports 1. between A and B. Fig. 2-3-D Remove the Plate Clamper, Magnet Clamper and Clamper. Check Hook Check Hook Plate Clamper Magnet Clamper Main Frame Loading Motor PCB Ass’y Clamper Check Hook Fig. 2-5-A Fig. 2-3-E DV-588A-S...
Page 66
Remove the Switch PCB Ass'y. 8.0 ± 0.2mm Remove the screw 4. Remove the Gear Feed. Feed Motor Remove the 2 screws 5. Remove the Feed Motor. Remove the Gear Motor. Safety surface for pressing of the insert. Fig. 2-7-C DV-588A-S...
Page 67
When installing the FFC, fold it correctly and install it as shown from Fig. 2-8. NOTE Do not make the folding lines except the specified positions for the FFC. [ 24 pin FFC ] Printing _Serface 85±1 mm Reinforcement Plat To Pick Up PCB Fig. 2-8 DV-588A-S...
Page 69
TV Encoder Module Videop RF Amplifier Video DAC Servo IO Servo Motor Processor Video Drive Processor interlacer Spindle Control FLASH MPEG-1/2 Audio JPEG Memory Video Decoder Controller DRAM System Audio Parser Audio Output CPPM/CPRM SPDIF System GPIO 32-bit RISC IR/VFD DV-588A-S...
Page 70
While External FLASH size <= 2MB: 45 NC – – Version AD input port 0, or DVDD3 – 3.3V power pin for internal digital circuitry GPIO FG(Diogital pin) – Motor Hall sensor input, or Version AD input 8 90 ALE Microcontroller address latch enable DV-588A-S...
Page 71
133 RD9 DRAM data 9 185 NC – – 134 DVSS – 3.3V Ground pin for internal digital circuitry 186 NC – – 135 RD8 DRAM data 8 187 NC – – 136 DQS1 GPIO 188 NC – – DV-588A-S...
Page 72
236 LPFIP The positive input terminal of loop filter amplifier GPIO 237 LPFIN The negative input terminal of loop filter amplifier 212 DVDD3 – 3.3V power pin for internal digital circuitry 238 LPFOP The positive output of loop filter amplifier DV-588A-S...
Page 73
RF path. Connect 246 RFRPAC RF ripple detect input (through AC-coupling) an external 15K resistor to this pin and 247 HRFZC High frequency RF ripple zero crossing AVSS 248 CRTPLP Defect level filter capacitor connecting 256 AVDD3 – Analog power 3.3V DV-588A-S...
Page 77
Logic Power Supply 13,43 High-Voltage Segment Output Pins 14 to SG1/KS1 to SG16/KS16 Also acts as the Key Source – Pull-Down Level 31 to SG17/GR12 to SG24/GR5 High Voltage Segment/Grid Output Pins 39 to GR4 to GR1 High-Voltage Grid Output Pins DV-588A-S...
Page 78
WMA files – do not use for other file types) it may or may not be played with this product. – If you need further information about playability of DualDisc, please see ‘Service & Support’ on the Pioneer web site (www.pioneerelectronics.com) DV-588A-S...
Page 79
DivXNetworks, Inc. and are used format) are not compatible with this player. under license. Check the DVD-R/RW or CD-R/RW software • Some external subtitle files may be disc boxes for additional compatibility displayed incorrectly or not at all. information. DV-588A-S...
8. PANEL FACILITIES 8.1 FRONT PANEL SECTION Front panel STANDBY/ON MENU 10 ENTER & cursor buttons 11 TOP MENU 12 Display OPEN/CLOSE RW Compatible 14 Disc tray HOME MENU 15 Remote control sensor RETURN DV-588A-S...
Indicates that the character display is showing a DVD title number. Lights during multi-angle scenes on a DVD disc. PRGSVE Lights when the player is set to output progressive scan video. Lights in any of the repeat play modes. DV-588A-S...
Press to pause playback; press again to restart. 12 PLAY MODE Press to display the Play Mode menu. (You can also get to the Play Mode menu by pressing HOME MENU and selecting Play Mode). Press to jump to the beginning of the current DV-588A-S...
Page 83
Use to select menu options, etc. playing. 24 ZOOM 18 MENU Press to change the zoom level. Press to display a DVD disc menu, or the Disc Navigator if a VR format DVD-RW, CD, Video CD , MP3, WMA or JPEG disc is loaded. DV-588A-S...
• Before shipping out the product, be sure to clean the following positions by using the prescribed cleaning tools: Position to be cleaned Position to be cleaned Cleaning tools Cleaning tools Remark Remark Pickup leneses Cleaning liquid : GEM1004 Refer to "2.3 05 DVD MECHA SECTION" , "7.2 DISASSEMBLY SECTION". Cleaning paper : GED-008 DV-588A-S...