Healthrider 15.5 S User Manual page 9

8. Apply grease to the axle on the left Disc
Crossbar (16).
Slide the Left Pedal Arm (11) onto the axle on
the left Disc Crossbar (16).
Apply grease to a Large Wave Washer (76) and
press it onto the end of the Left Pedal Arm (11).
Tighten an M10 x 27mm Patch Screw (40) and
an M10 Washer (35) into the axle.
Then, press a Pedal Arm Cap (74) into the Left
Pedal Arm (11).
Next, apply grease to an M10 Bolt Set (25).
Hold the lower end of the left Upper Body Leg
(5) inside the bracket on the Left Pedal Arm
(11).
Attach the Upper Body Leg (5) to the Left Pedal
Arm (11) with the M10 Bolt Set (25). Do not
overtighten the Bolt Set; the Upper Body
Leg must pivot freely.
Attach the Right Pedal Arm (not shown) to
the right side of the elliptical exerciser in the
same way.
See step 5. Tighten the M10 x 74mm Button
Bolts (7).
See step 6. Tighten the M8 x 45mm Button
Bolts (50).
9. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
8
Grease
11
35
40
74
Grease
25
11
9
16
76
2
5
25