Healthrider 15.5 S User Manual page 8

6. Identify the Left Upper Body Arm (6), which is
marked with a "Left" sticker.
Insert the Left Upper Body Arm (6) into one of
the Upper Body Legs (5); make sure that the
hexagonal holes are on the indicated side.
Attach the Left Upper Body Arm (6) with two M8
x 45mm Button Bolts (50) and two M8 Locknuts
(38). Make sure that the Locknuts are inside
the hexagonal holes. Do not tighten the
Button Bolts yet.
Apply a generous amount of the included
grease to the Pivot Axle (26). Then, insert the
Pivot Axle into the Upright (2), and center it.
Turn an Upper Body Arm Spacer (47) so that
the small arrow on the Upper Body Arm Spacer
is pointing downward, and slide the Upper Body
Arm Spacer onto the Left Upper Body Arm (6).
Next, slide the Left Upper Body Arm (6) onto
the Pivot Axle (26).
Tighten an M8 x 25mm Patch Screw (56), an
Upper Body Arm Washer (55), and a Wave
Washer (69) into the Pivot Axle (26).
Then, press the tabs on a Upper Body Arm Cap
(46) into the Upper Body Arm Spacer (47).
Assemble the Right Upper Body Arm (8) and
the other Upper Body Leg (5) in the same
way.
7. Identify the Left Pedal Arm (11), which is
marked with a "Left" sticker.
Attach the Left Pedal (13) to the Left Pedal Arm
(11) with two M8 x 52mm Button Screws (27),
two M8 Split Washers (28), and two M8
Washers (71).
Attach the Right Pedal (not shown) in the
same way.
6
Grease
6
55
56
Arrow
46
69
50
7
13
11
71
28
8
8
26
47
2
38
5
Hexagonal
Holes
5
71
28
27