Using No Fading Output; Adjusting Non Fading Output Level; Using The High Pass Filter - Pioneer DEH-P8400MP Operation Manual

Section
Audio Adjustments
07

Using no fading output

When the non fading output setting is on, the
audio signal does not pass through this unit's
low pass filter (for the subwoofer), but is output
through the RCA output.
1 Press
OPEN
2 Press
AUDIO
on/off mode.
When the subwoofer controller setting is
, you can select non fading output
Control:EXT
on/off mode. Press
appears in the display.
3 Press 5 to turn non fading output on.
appears in the display. non fading
NonFad ON
output is now on.
• You can turn off non fading output by pressing
∞.

Adjusting non fading output level

When the non fading output is on, you can
adjust the level of non fading output.
1 Press
OPEN
2 Press
AUDIO
setting mode.
Press until
AUDIO
play.
3 Press 5 or ∞ to adjust the output level of
the non fading.
Each press of 5 or ∞ increases or decreases
the level of the non fading.
as the level is increased or decreased.
Press 5 or ∞ until you see the desired value
displayed.
42 En
to open the front panel.
to select non fading output
until
AUDIO NonFad ON
to open the front panel.
to select non fading output
appears in the dis-
NonFad 0
– is displayed
+6 –6

Using the high pass filter

When you do not want low sounds from the
subwoofer output frequency range to play from
the front or rear speakers, switch the HPF (high
pass filter) on. Only frequencies higher than
those in the selected range are output from the
front and rear speakers.
1 Press
OPEN
2 Press
S.W AUDIO
Press
AUDIO
3 Press 5 to turn high pass filter on.
appears in the display. High pass
HPF 80 Hz
filter is now on.
• To turn high pass filter off, press ∞.
4 Press 2 or 3 to select a high pass filter
range.
Press 2 or 3 until the desired cut-off frequency
appears in the display.
— —
50 80 125
• Only frequencies higher than those in the
selected range are output from the front or rear
speakers.
Note
• If you switch the
tion is automatically switched off. By switch-
ing the
H.P.F
mode, you can combine
SFEQ
with
SFEQ
to open the front panel.
to select .
HPF
until appears in the display.
HPF
(Hz)
mode, the
SFEQ
. function on after selecting the
H.P.F.
function.
. func-
H.P.F
function