Subwoofer Setting Adjustment (Sub W-2); Non-Fading Output (Non Fad E -1) - Pioneer DEH-P9200R Operation Manuall

Subwoofer Setting Adjustment (Sub W-2)

When the Subwoofer output is ON, you can adjust the cut-off frequency and the output
level of Subwoofer.
1. Press the AUDIO button and select the Subwoofer setting mode
(Sub W-2) in the Audio Menu.
2. Select the frequency to 50 Hz,
80 Hz or 125 Hz with the 2/3
buttons.
3. Increase or decrease the output
level with the 5/∞ buttons.
The display shows "+6" – "–6".
Note:
• You can select the Subwoofer setting mode only when Subwoofer output is switched ON in the
Subwoofer ON/OFF mode.
Non-Fading Output (Non Fad
When the Non-Fading Output setting is ON, the audio signal does not pass through this
unit's low pass filter (for the Subwoofer), but is output through the RCA output.
Note:
• When the Subwoofer Controller setting is only "Sub woofer control External", you can switch the
Non-Fading Output ON/OFF mode. (Refer to page 55.)
1. Press the AUDIO button and select the Non-Fading Output ON/OFF
mode (Non Fad
2. Switch the Non-Fading output
ON/OFF with the 5/∞ buttons.
-1)
E
-1) in the Audio Menu.
E
46