Spare Parts, Accessories - 3M Peltor MT7H7A4610-NA User Manual

EN
6. FCC Regulations and Licensing Application Information
6.1 FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes
or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment. Before any station transmits on any channel authorized in the GMRS from an point (a geographical location) within
or over the territorial limits of any area where radio services are regulated by the FCC, the responsible party must obtain a
license (a written authorization from the FCC for a GMRS system .
6.2 FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. Do not transmit for more than 50% of the total transceiver use time; transmitting over 50% of the total
use time may exceed the limits in accordance to the FCC RF exposure requirements. Nominal transceiver operation is 5%
transmission time, 5% reception time and 90% stand-by time.
6.3 IC Warning
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following
two conditions:
(1)This device may not cause interference and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser)
gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that, the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary
for successful communication.
7.CAUTION
When set to full gain the earphones can produce an equivalent sound level of up to 87dB(A). This is considered safe for daily
8-hours use, as long as the time spent in receiving mode does not exceed 2,5 hours. If the time spent listening to the earphones
exceeds 2,5 hours per day the gain setting must be reduced below maximum. One step below maximum gain produces an equi-
valent sound level of 82 dB(A), considered safe even if used in the listen mode, in noise, for a full 8-hours day.
If after wearing this device, tinnitus (ringing or buzzing in the ears) is heard, or your hearing seems muffled or dulled, or for any
other reason you suspect a hearing problem, the volume levels should be reduced and the fit, condition, and adequacy of this
device should be checked for the noise in which it is being worn. If the condition persists see an audiologist or physician for a
professional review.
8. SPARE PARTS/ACCESSORIES
3M™ Peltor™ HY79 Hygiene kit
Replaceable hygiene kit consisting of two attenuation cushions, two foam rings and two snap-in ear cushions. Replace at least
twice a year to ensure constant attenuation, hygiene and comfort.
3M™ Peltor™ HY100A Single-use protectors
A single-use protector that is easy to fit to the ear cushions. Pack of 100 pairs.
3M™ Peltor™ HYM1000 Microphone protector
Moisture-resistant and wind-resistant hygienic tape that protects the speech microphone and extends its life at the same time.
Pack of 16 feet (5 meters) is sufficient for around 50 replacements.
3M™ Peltor™ MT7N-02 Dynamic microphone
Supplied as standard with product.
3M™ Peltor™ M42/1 Wind shield for microphone dynamic microphone
3M™ Peltor™ ACK081 Battery
Supplied as standard with product.
10