Mitsubishi Electric Q03UDVCPU User Manual page 148

*1 The SP.FWRITE or SP.FREAD instruction in the program will write or read the file respectively.
For details, refer to the following manual.
MELSEC-Q/L Programming Manual (Common Instruction)
*2 Files can be written to the program memory only when the CPU module is in the STOP state.
*3 Write destination is the program cache memory.
The user should back up files using the "pm-write" command as required. (
*4 The following number of files can be stored using FTP.
[Maximum number of files storable on the drive - 1]
*5 Except for the High-speed Universal model QCPU, file names are SRCINF1M.CAB and SRCINF2M.CAB for Simple
projects (with labels), and SRCINF1I.CAB and SRCINF2I.CAB for Structured projects.
For the High-speed Universal model QCPU, file names are SRCINF1M.C32 and SRCINF2M.C32 for Simple projects
(with labels), and SRCINF1I.C32 and SRCINF2I.C32 for Structured projects.
*6 The file name depends on the connection type of the data backup/restoration. (
Manual)
*7 When the block password for which "Execution Program Protection Setting" is enabled is set, files cannot be transferred
by using the command "get" and "mget", and file names cannot be changed by using the command "rename".
146
Page 149, Section 9.4.1)
iQ Sensor Solution Reference