Starting A Program - Miele PG 8527 Operating And Installation Instructions

Operation
Opening and closing the door
^ Press the a button.
The door opens or closes.
To open the door on the clean side
(PG 8528), note the following:
– programs with a process
requirement must have been
completed without fault,
or
– the gate function is activated, i. e.,
door mechanism is set to one of the
following parameters:
- Sluice,
- Door clean + Sluice,
- Door unclean + Sluice.
(see "Machine functions / Door
mechanism" in the Programming
manual).
,
If the pre-heater has been
programmed for heating. Always
beware of hot water or steam exiting
the open door. Looking from the
unclean side, the inlet pipe for the
pre-heater is located beneath the
right basket guide rail.
32

Starting a program

You can find detailed and important
information regarding the Miele
default programs in the "Program
chart" of the Programming Manual.
If a barcode scanner is connected
to the labwasher and the user or
load scan is activated, the selected
program cannot be started until
scanning has been completed.
For more information see "Barcode
scanner".