Miele PG 8527 Operating And Installation Instructions page 5

~
Take care when handling liquids
such as detergents, neutralizing
agents, wetting agents and rinse aids.
These may contain irritant or corrosive
ingredients, acids or alkalis. Never use
any organic solvents, as the danger of
explosion exists. Wear protective
gloves and goggles. The
manufacturer's safety conditions must
be observed at all times.
~
The water in the machine must not
be used as drinking water.
~
Be careful when sorting items with
sharp pointed ends. Position them in
the machine so that you do not hurt
yourself or create a danger for others.
~
When using this machine regard the
high temperatures and be especially
careful not to scald or burn yourself.
When opening the door bypassing the
electrical lock, a danger of burning,
scalding and corrosion exist. Let mobile
units, inserts and cleaned items cool
before touching them. Any water which
may remain in containers will be very
hot and must be emptied into the wash
cabinet.
~
If you are exposed to toxic vapors or
processing chemicals, consult the
manufacturer's material safety data
sheets for emergency procedures.
IMPORTANT SAFETY INSTRUCTIONS
~
inserts, and loads to cool before
removing. Be sure to empty any water
from concave items into the wash
cabinet before removing.
~
open the door to allow the items and
inserts to cool.
~
programmed to "Pre-heater standby",
be particularly careful of hot water and
steam when opening the door. Danger
of burning or scalding. The water inlet
pipe to the wash cabinet is located, as
viewed from the loading side,
underneath the basket runner on the
left hand side.
~
pressure of 145 psi. This corresponds
to a water steam temperature of 354°F
(179 °C).
~
with a water or high pressure hose.
~
power supply by either removing the
fuse, unplugging the unit or manually
"tripping" the circuit breaker.
Always allow mobile units, modules,
After drying with the drying unit
If the pre-heater has been
Steam heating is permissible up to a
Never clean the machine near or
Before servicing, disconnect the
,
Mount on non-combustible floors
only!
5