Streaming Video (Remote Display); Stream Live To A Pc - Fluke Ti200 User Manual

Ti200, Ti300, Ti400, Ti450, Ti450SF6, Ti480
Users Manual
If the radio is authorized in your country, an authorization code appears on the web page.
If the radio is not yet authorized in your country, Fluke will contact you when the radio is
authorized for use in your country.
4. On the Imager,
a. Push  or tap Enter Code.
b. Type in the authorization code from the website. (The authorization code is not case sensitive.)
c. Push  or Done.
A message appears on the Imager display that shows the wireless communication is enabled.
If a message appears that says the authorization code is invalid:
•
Make sure you entered the correct serial number from the Imager into the website.
•
Make sure you entered the correct authorization code from the website into the Imager.
d. Tap Ok.
5. Connect to a wireless device, if desired. See Wireless Connectivity.

Streaming Video (Remote Display)

The Imager can stream live infrared and IR-Fusion technology video to a PC that has SmartView
software installed, to the Fluke Connect app (where available), or to an HDMI compatible device.

Stream Live to a PC

To stream live to a PC through a USB connection:
1. Install the latest version of the firmware on the Imager. See Download Firmware.
2. On the PC, open the SmartView software.
3. Connect the USB A connector end of the cable into your PC and the USB Micro B connector end
into the Imager.
Some Imagers have both A and Micro B connector jacks. Make sure to use the Micro B jack on
the Imager
appears on the SmartView software toolbar menu.
4. On the PC, choose Remote Display from
36
Note
Note
.