Camera Menu - Fluke Ti200 User Manual

Camera Menu

Table 12 lists the options in the Camera menu.
Option Menu
On
LaserSharp
Autofocus
Off
Backlight <options>
Torch --
Video/Audio
Video
Video ONLY
Record Video
Start Capture
Interval
Auto Capture
Image Count
Manual
Trigger
Temp Trigger
Set Temp
Trigger
Table 12. Camera Menu
Option
Turns on LaserSharp Autofocus to automatically focus on a
target. See LaserSharp Auto Focus System.
Turns off LaserSharp Autofocus to use the Advanced manual
focus. See LaserSharp Auto Focus System.
Select to set the brightness level of the display.
Turns on/off the built in flashlight.
Select to record video and audio when Record Video is
selected.
Select to record video only when Record Video is selected.
Select to start recording a video. See Video.
Select to capture and save an infrared image, or series of
images based on Auto Capture settings.
Sets the number of hours, minutes, or seconds between image
captures.
The minimum interval available can be affected by the file
type and visible light camera settings. Some combinations
create larger file sizes that take longer to capture and save
and create a higher minimum interval compared to others.
Sets a number of images to capture. Or, select Maximum
Memory to capture and save images until the chosen storage
memory is full or the battery runs out of power.
Select to immediately capture images when Start Capture is
selected.
Select to capture images when a value is above or below a set
temperature limit when Start Capture is selected.
With Temp Trigger selected, set the temperature and conditions
to trigger the auto capture of images.
Description
Note
Thermal Imagers
Menus
21