Before You Start; What's In The Box; Putting The Batteries In The Remote Control - Pioneer BDP-LX52 Operating Instructions Manual

Chapter 1
01

Before you start

What's in the box

• Remote control x 1
• Video/audio cable (yellow/white/red plugs) x 1
• AA/R6 dry cell batteries x 2
• Warranty card
• Operating instructions (this document)
• U.K., Australia and New Zealand models: Power cord x 1
Others: Power cord x 2
Putting the batteries in the
remote control
1 Open the rear cover.
2 Insert the batteries (AA/R6 x 2).
Insert as indicated by the / marks into the battery
compartment.
3 Close the rear cover.
Close securely (a click should be heard).
Caution
• Do not use any batteries other than the ones
specified. Also, do not use a new battery together with
an old one.
6
En
• When loading the batteries into the remote control,
• Do not heat batteries, disassemble them, or throw
• Batteries may have different voltages, even if they look
• To prevent leakage of battery fluid, remove the
• When disposing of used batteries, please comply with
• WARNING
Press lightly on this
part and slide into
the direction of the
arrow.
Insert the negative
() side first.
set them in the proper direction, as indicated by the
polarity marks ( and ).
them into flames or water.
similar. Do not use different kinds of batteries
together.
batteries if you do not plan to use the remote control
for a long period of time (1 month or more). If the fluid
should leak, wipe it carefully off the inside of the case,
then insert new batteries. If a battery should leak and
the fluid should get on your skin, flush it off with large
quantities of water.
governmental regulations or environmental public
institution's rules that apply in your country/area.
Do not use or store batteries in direct sunlight or
other excessively hot place, such as inside a car or
near a heater. This can cause batteries to leak,
overheat, explode or catch fire. It can also reduce the
life or performance of batteries.
D3-4-2-3-3_En