Adjusting The Speaker Output Levels - Pioneer SUPERTUNERIIID+ AVH-P7850DVD Operation Manual

Section
17 Audio Adjustments
3 Touch or
tween each speaker and the listening posi-
tion.
Each time you touch
creases the distance. 0.0cm to 500.0cm is dis-
played as the distance is increased or
decreased.
# You can mute the selected speaker unit by
touching MUTE. To cancel muting, touch MUTE
again.
# You cannot select speakers whose size is set
at OFF.
Note
You can store the adjusted setting in memory by
using MEMORY. For details concerning opera-
tion, refer to Storing the adjusted audio settings in
memory on the next page.
Adjusting the speaker
output levels
You can adjust the speaker output level of
each speaker unit.
Recalling the speaker output
level settings
% Touch SPEAKER LEVEL on the sound
setting menu to select the speaker output
level setting.
Touch SPEAKER LEVEL repeatedly to switch
between the following speaker output level set-
tings:
CUSTOM1—CUSTOM2—CUSTOM3—AUTO
—LAST MEMORY
# You can select LAST MEMORY only when the
adjusted speaker output level setting is not mem-
orized in this unit.
# You cannot select AUTO when NETWORK
has been selected. (Refer to Switching the DSP
setting mode on page 104.)
90
En
to adjust the distance be-
or it increases or de-
# When STANDARD has been selected, you
cannot select AUTO if auto TA and EQ has not
been carried out.
Adjusting the speaker output
levels using a test tone
This function allows you to easily get the over-
all balance right among the speakers.
1 Recall the speaker output level settings
you want to adjust.
Refer to Recalling the speaker output level set-
tings on this page.
2 Touch ADJ. next to SPEAKER LEVEL on
the sound setting menu and then touch
TEST TONE.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
Front left speaker—Front center speaker—
Front right speaker—Rear right speaker—Rear
center speaker—Rear left speaker—Subwoo-
fer
Check each speaker output level. If no adjust-
ments are needed, perform step 4 to stop the
test tone.
# Using TEST TONE, the tweeters and the front
speakers are adjusted same time. To adjust them
separately, please refer to Adjusting the speaker
output levels finely on the next page.
# The settings do not appear for speakers
whose size is set OFF.
3 Touch or to adjust the speaker out-
put level.
Each time you touch
creases the speaker output level. –24dB to
+10dB is displayed as the level is increased or
decreased.
or it increases or de-