7.3. Setting Up the Controller
Set up the Controller.
7.3.1.
Starting the Sysmac Studio and Installing the ESI File
Install the ESI file for the WAGO-I/O-SYSTEM Fieldbus Coupler in the Sysmac Studio.
Install the Sysmac Studio and USB driver in the Personal computer beforehand.
Connect the Ethernet cable to
1
the built-in EtherCAT port
(PORT2) of the Controller and
connect the USB cable to the
peripheral (USB) port.
As shown in 5.2. Device
Configuration, connect the
Personal computer,
WAGO-I/O-SYSTEM Fieldbus
Coupler, and Controller.
Turn ON the power supply to the
2
Controller and the System
supply and the Field supply to
the WAGO-I/O-SYSTEM
Fieldbus Coupler.
Start the Sysmac Studio.
3
Click the Connect to Controller
Button.
* If a confirmation dialog for an
access right is displayed at
start, select to start.
7.EtherCAT
CPU Unit
Controller
USB cable
Power Supply Unit
Connection Procedure
End Cover
Ethernet
cable
11