Table of Contents
Advertisement
PLM860SAW Manual.qxd
7/31/03
Operation and Controls
PLM860SAW
PLM860SAW
Front Panel Control
1.
Power Indicator:
The LED indicates unit is operating.
2.
Test Point:
The -30 dB RF output test point is used to set the RF output level and
monitor channel performance.
3.
RF Output Level:
This control sets the RF output level.
1
VIDEO IN
Back Panel Control
1.
Video In:
The baseband video from the satellite receiver or VCR is connected
to this F connector.
2.
Audio In:
The baseband audio from the satellite receiver or VCR is connected to
this F connector.
3.
RF Out:
The modulated output signal is available on this "F" connector.
6
Ph: 800-421-6511
Rev. 06/03
2:28 PM
Page 6
1
2
860MHz Channelized-Agile PLL SAW-Filtered A/V Modulator
POWER
TEST
POINT
CH-
-30dB
www.picomacom.com
4
3
RF OUTPUT
AUDIO
LEVEL
MODULATION
4.
Audio Modulation:
This control is used to set the audio modulation level.
5.
Aural Level:
This potentiometer controls the level of the audio RF carrier.
6.
Video Modulation:
This control is used to set the video modulation level.
2
3
RF OUT
AUDIO IN
4.
Convenience Outlet:
Allows looping of power between units.
5.
Power Cord:
The three-prong type power plug connects to a 120 VAC, 60 Hz elec-
trical output.
5
6
AURAL
VIDEO
LEVEL
MODULATION
5
4
120VAC
60Hz 10W
600W MAX
Advertisement
Table of Contents
