Table of Contents
Advertisement
PCFM Manual.qxd
7/10/03
1:14 PM
Operation and Controls
PCFM
PCFM
Front Panel Control
1.
Power Indicator:
The LED indicates unit is operating.
2.
Station Display:
Seven-segment display indicates FM frequency.
3.
Freq. Select Controls:
Push these buttons to change channel to higher or lower
frequency.
4.
Mono/Stereo:
Slide switch selects mono or stereo modes.
1
RF OUT
Back Panel Control
1.
RF Out:
Connect this port to the distribution system.
2.
Audio In:
Connect a 1 V p-p (2 V p-p max.) mono or stereo signal
source from a satellite receiver or VCR.
6
Ph: 800-421-6511
Rev. 07/03
Page 6
1
Agile FM Stereo Audio Modulator
POWER
2
AUDIO IN
R
L
www.picomacom.com
3
4
5
2
AUDIO MODULATION
FREQ.
MONO STEREO
5.
Audio Modulation:
The audio modulation level (loudness) is set with this control.
6.
RF Output:
The RF level is set with this control.
7.
Test Point:
The -20 dB RF output test point is used to set the RF output
level and monitor station performance.
4.
Convenience Outlet:
Allows looping of power between units.
5.
Power Cord:
The three-prong type power plug connects to a 120 VAC,
60 Hz electrical outlet.
6
7
R.F OUT
TEST POINT
-20 DB
4
3
120VAC
60Hz 10W
600W MAX
Advertisement
Table of Contents
