Operation And Controls - Pico Macom VSM-3/4S Installation And Operation Manual

Operation and Controls

VSM-3/4S
Operation
Turn the power on to both your television and your video component.
1.
Turn both your TV and the RF Modulator to the same channel (3 or 4, whichever gives you the clearest pic-
2.
ture) using the switch in the back of the modulator.
3. Set the OHMS switch on the back of the modulator to 75 or 1K; whichever gives you the clearest picture. The
1K setting is recommended for video-game consoles; the 75 setting is recommended for all other applications.
The light on the front of the RF Modulator will turn on when it is receiving a video signal from your video
4.
component. The video signal can be viewed on channel 3 or 4 (whichever you selected in step #1).
If the light is not on, either:
a. Your video component is not sending a signal (not turned on, not playing, etc.).
b. The RF Modulator and your video component are not connected properly, check
all your connections.
6 Ph:800-421-6511
Rev. 05/03
www.picomacom.com