Adding - Western Digital My Book Duo User Manual

Figure 8.1
1. As is illustrated above in Figure 8.1, reveal the hard drives by opening the top lid
from the rear edge with the included Disk Replacement Tool.
2. Each hard drive is held in place by an attached tray and the tray has a plastic
latch on one end.
▪ Gently press down on the plastic latch with your index finger so that it
unlatches from the metal frame of the device.
▪ While gently pressing down on the plastic latch, grab the plastic tray with
your fingertips and gently pull. The tray and hard drive should easily lift up or
slide out.
3. Once the hard drive and tray combination are completely removed from the
unit, remove the plastic tray from the hard drive.
▪ The tray is attached to the hard drive with four pins.
▪ As is illustrated above in Figure 8.1, gently flex the tray so that the pins come
out of the sides of the hard drive. Remove and save the tray.
hard drive to WD with the tray. The tray will not be returned to you.
▪ After the tray is removed, remove the one screw from the side of the HDD as
is illustrated in Figure 8.1. Save this screw for the HDD that is put back into
the unit. This screw will not be included with a replacement HDD.

Adding

Before adding a hard drive to your My Book Duo device, make sure there is no hard
drive in the slot where it will be installed and that power to the unit is turned off. If
you need to first remove a hard drive, follow the instructions above.
Figure 8.2
My Book Duo
User Manual
Troubleshooting
return a
Do not
28