JVC TH-SW9 Service Manual page 32

4.3 Method of displaying region code
(1) Set the main body at test mode.
(2) Press "MENU" key of the remote controller three times. Then, region code are displayed in the FL display.
4.4 Initialization method
Please initialize according to the following procedures in the following case:
• Just after you upgrade the firmware.
• After you confirm the symptoms that a customer points out. First Initialize, and then confirm whether the symptoms are improved or
not.
• After servicing, before returning the main body to a customer. (Initialized main body should be returned to a customer.)
(1) Set the main body at test mode.
(2) Press "PAUSE" key of the main body.
(3) When initialization is completed, "00" and "RDS" is displayed in the FL display.
4.5 Display of current value of laser
(1) Set the main body at test mode.
(2) Press "MENU" key of the remote controller five times. Then, FL display is displayed "CHECK".
(3) The laser current value can be switched between the value of CD and that of DVD by pressing the following key of the remote
controller.
• The number shown in the FL display shows mA of current value of laser.
• The first two numbers ("14" in "1419") shows current value of laser at the time of adjustment after the latest all-initialization, 14mA
in this example.
• The last two numbers ("19" in "1419") shows the present current value of laser, 19mA in this example.
• The first two numbers ("14" in "1419") usually shows current value of laser at the time of shipment, so you can see how the product
has been deteriorated by comparing the first two numbers ("14" in "1419") and the last two numbers ("19" in "1419").
CD and DVD:
The laser current value of 80mA or less in normal. The laser current diode of the pickup has been deteriorated.
• To return to test mode, press "STOP" key of the main body.
4 key
(laser of CD)
1-32 (No.MB260)
FL Display (Example)
Remote controller "4" key --- Laser of CD
1419 0000
Remote controller "5" key --- Laser of DVD
Remote controller "6" key --- Jitter measurement mode
MENU key
(switch of mode)
5 key
(laser of DVD)
6 key
(display of jitter value)
PLAY key
(for test mode
and jitter value)
FL display STANDBY/ON key
(for test mode)
PAUSE key
(for initialize)