JVC TH-SW9 Service Manual page 28

3.5.2 Removing the front board
(See Figs.2 and 3)
• Prior to performing the following procedures, remove he side
panel (L) and side panel (R).
(1) From the right side of the receiver assembly, remove the
four screws B attaching the front board. (See Fig.2)
(2) From the back side of the receiver assembly, remove two
screws C attaching the front board. (See Fig.3)
(3) From the right side of the receiver assembly, take out the
front board, and disconnect the wires from the connectors
CN151, CN152, CN171
(See Fig.2)
Caution:
When attaching the front board, exchange the spacer for the
new part. If the front board is attached without exchanging the
spacer, the chip parts may be damaged. (See Fig.2)
3.5.3 Removing the rear panel
(See Figs.3 and 4)
• Prior to performing the following procedures, remove he side
panel (L), side panel (R) and front board.
(1) From the back side of the receiver assembly, remove the
two screws D attaching the rear panel. (See Fig.3)
(2) From the right side of the receiver assembly, cut off the tie
bands. (See Fig.4)
(3) Take out the rear panel with RF module. (See Fig.4)
1-28 (No.MB260)
and CN172 on the front board.
CN172
CN151
CN171
CN152
Spacer
B
Fig.2
D
Fig.3
RF module
Tie bands
Fig.4
Front board
C
Rear panel
Rear panel