JVC TH-SW9 Service Manual page 14

3.2 Front panel assembly section
• Prior to performing the following procedures, remove the top cover and front panel assembly.
3.2.1 Removing the TX ant board
(See Fig.1)
(1) From the inside of the front panel assembly, release the
two claws a attaching the TX ant board.
(2) Take out the TX ant board from the front panel assembly.
3.2.2 Removing the FL board
(See Fig.2)
• Prior to performing the following procedure, remove the TX ant
board.
(1) From the inside of the front panel assembly, remove the
screw A attaching the FL board.
(2) Take out the FL board from the front panel assembly.
Reference:
• When attaching the FL board, align the section b of the front
panel assembly to the right side of the FL board.
3.2.3 Removing the front cover and SW board
(See Figs.3 and 4)
• Prior to performing the following procedure, remove the TX ant
board.
(1) From the front side of the front panel assembly, remove the
volume jog from the front panel assembly forward. (See
Fig.3)
(2) From the inside of the front panel assembly, release the
seven claws d attaching the front cover. (See Fig.4)
(3) Remove the front cover to the direction of the arrow. (See
Fig.4)
(4) Remove the three screws B attaching the SW board, and
take out the SW board. (See Fig.4)
1-14 (No.MB260)
TX aht board
Claw a
Fig.1
• After attaching the FL board, passing the card wire through
the Hook c.
FL board
A
Fig.2
Volume jog
Fig.3
SW board
B
Fig.4
Section b
Hooks c
Front assembly
Claws d
Front cover