Getting Started; Level Setting Procedure - PRESONUS StudioLive 16.0.2 USB Owner's Manual

2

Getting Started

2.1

Level Setting Procedure

2 Getting Started
2.1 Level Setting Procedure
Before you begin, here are a few general rules of thumb:
Always turn down the Main fader and both the Monitor and Phones
4
knobs in the Monitor section down before making connections.
Before plugging or unplugging a microphone while other channels
4
are active, mute the channel to which you are connecting.
Your faders should be set on or near the "U" mark whenever possible.
4
The "U" indicates unity gain, meaning the signal is neither boosted
nor attenuated. If the main output of your StudioLive is too high or
too low when your faders are at or near unity, you can use the main
output-level knob on the rear panel of the StudioLive to adjust the
level up or down until you have achieved the optimal volume.
Do not allow your inputs to clip. Watch the level meters; when the LEDs near
4
the Clip mark, the top LED will illuminate, indicating that the analog-to-digital
converters are in danger of being overdriven. Overdriving the converters
will cause digital distortion, which sounds terrible. The XMAX™ preamps
in your StudioLive provide plenty of headroom; take advantage of it.
Your P.A. and studio equipment should be powered on in the following order:
Sound sources (keyboards, direct boxes, microphones,
4
etc.) connected to the StudioLive inputs
StudioLive mixer
4
Computer (if applicable)
4
Power amplifiers or powered monitors
4
When it's time to power down, your system should be turned off in the reverse
order. Now that you know what not to do, let's get some audio going!
1. Grab a microphone and a mic cable and plug them into the StudioLive's
Channel 1 mic input.
2. Connect the Main outs (TRS or XLR) of your StudioLive to your power amplifier
or powered monitors. If you're using passive speakers, connect them to your
power amplifier using speaker cable.
StudioLive™ 16.0.2 USB
Owner's Manual
4