Table of Contents
Advertisement
Access Point Installation Procedures
Mounting the AP3710/AP3725 to a Wall
Mounting the access point to a wall uses the mounting bracket that ships with the AP. Screws for
attaching the AP to a wall are not supplied with the product, however, because the type and
length of the screws will depend on the wall type and thickness.
Figure 2-3
1
Mounting Bracket, flat side up
2
Bracket Side Rails
3
Wall mounting holes
To attach the AP3710/AP3725 to a wall:
1.
Determine the spot on the wall where the AP is to be mounted, preferably high up on the wall
(near the ceiling for maximum radio wave dispersion) but in reach of the Ethernet cable and a
wall power outlet if you are not able to use Power over Ethernet.
2.
Place the flat side of the AP wall mounting bracket firmly against the wall surface, with the
locking tab facing out, and at the bottom.
3.
Secure the bracket to the wall with three screws (see
central wall mounting holes.
2-4 Installation
Wall Mounting Bracket
Note: The recommended orientation for the bracket is mounted on the wall vertically with the
locking tab at the bottom. This means the AP will be mounted with the cable ports at the top. The
bracket may be reversed (with locking tab at the top) so that the cable ports are at the bottom, but
this requires holding the AP in place until the locking screw is firmly screwed in.
Note: Screws for attaching the AP to a wall are not supplied with the product. The type and length
of the screws will depend on the wall type and thickness.
DRAFT
4
Locking Tab
5
Locking Screw Hole
6
Junction Box Screw Holes
Figure 2-4
on page 2-5) through the
Hide quick links:
Advertisement
Table of Contents
