Related Manuals for TRENDnet TE100-DX4PCI
Summary of Contents for TRENDnet TE100-DX4PCI
- Page 1 Ethernet Card for PCI TE100-DX4PCI 10/100 Mbps Fast Ethernet Hub Card for PCI Auto-Configurable User's Guide...
-
Page 2: Fcc Compliance Statement
NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. -
Page 3: Table Of Contents
Ethernet Card for PCI CONTENTS FCC Compliance Statement ......Section 1 Introduction ........Section 2 Installation ........Section 3 Configuration and Diagnostics ..Section 4 Drivers Installation ...... Section 5 Cable Specifications ..... Section 6 Troubleshooting ......Section 7 Specifications ......... -
Page 4: Section 1 Introduction
Ethernet Card forPCI Section 1 Introduction Your Ethernet hub card is a high performance network device that is designed to easily link four 10/100Mbps hub with a 100Mbps PCI interface card. The hub card consists of four (4) 10/100BASE-TX hub port to... -
Page 5: Section 2 Installation
Perform the following steps to install the adapter. 1. Turn off your computer and all peripherals. 2. Make a note of the cables and cords that are connected to the computer and disconnect them. 3. Remove your personal computer's cover (refer to the owner's manual of your personal computer). -
Page 6: Section 3 Configuration And Diagnostics
BIOS by entering your CMOS SETUP utility. To view the configuration parameters assigned by the BIOS, boot the computer to DOS, insert the diskette into the floppy drive and then execute the utility software EZRTS.EXE in the CONFIG directory. -
Page 7: Section 4 Drivers Installation
Ethernet Card for PCI Section 4 Drivers Installation Be sure to install the proper driver for the hub card to provides a connection between the 100Mbps MAC interface and the four 10/100Mbps nodes. You can use the drivers supplied by the software diskette that is compatible with your Networking Operating System. -
Page 8: Section 5 Cable Specifications
The Ethernet adapter is equipped with four RJ-45 connectors, the RJ-45 connector requires a corrsponding cable. This section describes each cable's specification. • Cable for RJ-45 connector for 10Mbps network Cable type: UTP with 2 twisted pairs 22, 24 or 26 AWG... -
Page 9: Section 6 Troubleshooting
Maximum cable length: 300'(100m) Section 6 Troubleshooting This section describes reasons for some adapter's and the actions to be taken to resolve the problems. • PCI scan specified, device not found Action: Verify that the PCI Ethernet adapter is physically installed properly. Otherwise, install the card in a different PCI slot or replace the adapter. -
Page 10: Section 7 Specifications
Ethernet Card forPCI pair (UTP) cable Action: Verify that the UTP cable is firmly attached and the cable type is correct for use. Section 7 Specifications IEEE 802.3 Standard: 10BASE-T 100BASE-TX Wiring Connector: RJ-45 Bus Characteristics: 32 bits ; PCI Local Bus... -
Page 11: Section 8 Led Indication
Operating Temperature: 0 to 55 degrees centigrade Operating Humidity: 10 to 90%, non-condensing Section 8 LED Indication The green LED displays the link status. If a good link is established on the given port, this green LED will be continuously lit.