Winegard WV750 Product Manual page 28

The button at the bottom left hand corner of the screen is basically a toggle switch
which changes the Network Adapter from DHCP to STATIC, or vice versa.
DHCP -
a)
If the modem, with which the controller is being configured, has DHCP enabled
then ensure first that the display at the top of this screen states NETWORK
SETUP - DHCP. If not, then tap on the "DHCP" button on the bottom left hand
corner of the screen.
b)
IP, Mask, Gateway and DNS information being distributed by the modem should
populate the main screen after a few seconds.
c)
Once DHCP data is present and verified, proceed to step 11.
STATIC -
a)
If the modem, with which this controller is being configured, does not have
DHCP enabled then ensure first that the display at the top of this screen states
NETWORK SETUP - STATIC. If not, then tap on the "STATIC" button on the
bottom left hand corner of the screen.
b)
After the Network Adapter is changed to Static mode, IP data can be entered by
tapping on each line of information at a time.
c)
After the tap a numeric pad screen will appear allowing entry of the IP
information with a NEXT button available to exit out of the numeric pad for each
entry.
d)
If an incorrect value is entered, the DEL button will backspace one character per
tap.
After the network configuration information has been entered and verified, tap on the
NEXT button to return to the NETWORK SETUP screen.
7451041 - V2.2
28