JVC XV-DDV1SL Service Manual page 16

3.2.6 Removing the feed motor
(See Figure 10, Figure 11, Figure 12)
• Remove the DVD servo control board.
• Remove the DVD traverse mechanism assembly.
(1) Remove the four screws F attaching the traverse mecha-
nism assembly.
(2) Take out the traverse mechanism assembly from the
mechanism base.
(3) Remove the screw C attaching the bracket and take out the
bracket.
(4) Disengage the claw f attaching the thrust spring and take
out the thrust spring.
(5) Pull out the lead screw in the direction of the arrow.
(6) Remove the feed gear M.
(7) Remove the feed motor wire that is soldered to the spindle
motor board.
(8) Remove the two screws G attaching the feed motor and
take out the feed motor.
1-16 (No.XA010)
Traverse
mechanism
assembly
Bracket
F
Fig.10
Spindle motor board
Remove the solders.
Thrust spring
Fig.11
Traverse
mechanism assembly
Fig.12
F
Mechanism
base
Feed motor
C F
Feed motor wire
Lead screw
Feed motor
Feed gear M
Claw f
G