JVC XV-DDV1SL Service Manual page 14

3.2.3 Removing the DVD pickup unit
(See Figure 3, Figure 4, Figure 5)
• Remove the DVD servo control board.
• Remove the DVD traverse mechanism assembly.
(1) From the top side of the DVD traverse mechanism assem-
bly, remove the screw C attaching the bracket.
(2) Remove the claw f attaching the thrust spring and then
take out the thrust spring.
(3) Remove the lead screw from the section g and then re-
move the shaft 1 from the section h.
(4) Disengage the section i of the DVD pickup unit and then re-
move the DVD pickup unit with the shaft 1.
(5) Pull the shaft 1 out of the DVD pickup unit.
(6) Remove the two screws D attaching the SW. actuator.
1-14 (No.XA010)
C
Bracket
DVD traverse mechanism assembly
Fig.3
DVD pickup unit
Section i
Shaft 2
Fig.4
SW. actuator
Shaft 1
Fig.5
DVD pickup unit
Shaft 1
Section h
Section g
Lead screw
Shaft 1
Claw f
Thrust spring
D
DVD pickup unit