Hookups With A Cable Box/Dss Receiver - Philips/Magnavox VCR 462 Owner's Manual

8 Hookups With a Cable Box/DSS Receiver

This connection allows you to view any channel. After you connect the Cable Box/DSS
Receiver, VCR, and TV as shown below, the features described on this page will be available.
1. Connect a Cable signal to the IN Jack
on the Cable Box/DSS Receiver.
IN OUT
2. Use an RF coaxial cable (supplied) to
connect the OUT Jack on the Cable
Box/DSS Receiver to the ANT(enna)
IN Jack on the VCR.
Recording or Viewing a Scrambled or
Unscrambled Channel
1
With the VCR on and in VCR position (the VCR light will appear
on the display panel), use the CHANNEL Up/Down buttons to set
the VCR to the Cable Box/DSS Receiver output channel (03 or
04). Set the CH3/CH4 switch on the back of the VCR to the same
channel.
2
Set the TV to the same output channel.
3
Use the CHANNEL Up/Down buttons at the Cable Box/DSS
Receiver to select the channel you want to watch or record.
Watching TV With the VCR Turned Off
1
Use the CHANNEL Up/Down buttons at the TV to set the TV to
the Cable Box/DSS Receiver output channel (03 or 04).
2
Use the CHANNEL Up/Down buttons at the Cable Box/DSS
Receiver to select the channel you want to watch.
Timer Recordings
With this connection, you may set a timer recording as described
on pages 34 - 36. However, remember the following:
•
Only program a timer recording for one channel at a time.
•
Set the TV and the VCR to the Cable Box/DSS Receiver output
channel (03 or 04).
•
When you are prompted to enter the channel you want to
record, select channel 03 or 04 (the Cable Box/DSS Receiver out-
put channel). This is step 5 on page 35.
•
Set your Cable Box/DSS Receiver to the channel you want to
record.
•
Leave the Cable Box/DSS Receiver on while recording.
3. Use a second RF
coaxial cable to con-
nect the RF OUT
Jack on the VCR to
the TV's ANTENNA
IN Jack.
CABLE
IN IN OUT OUT
BOX ANT.IN
R
AUDIO
L
RF OUT
VIDEO
CH3 CH4
• With this hookup, select channels at
• If your Cable Box/DSS Receiver has
• You can not view a channel other
• You cannot program channels with
ANTENNA IN Jack
Back of TV
(example only)
Helpful Hints
the Cable Box/DSS Receiver.
VIDEO/AUDIO OUT Jacks, use
video and audio cables to connect
these jacks to the VIDEO/AUDIO IN
Jacks on the VCR.
than the one you are recording.
(The instructions on page 33 do not
work with this hookup.)
this hookup (as discussed on page
12).
7 5
A N T
/
C A B
L E