Repeat Playback - Philips/Magnavox VCR 462 Owner's Manual

54 Repeat Playback

Follow the steps below to program the VCR to play a tape over
and over.
1
Press the VCR button, then press the MENU button.
TO SELECT PUSH NO. SHOWN
1 PROGRAM
2 VCR SET UP
3 TUNER SET UP
4 INPUT SELECT
5 SET CLOCK
6 SET REMOTE LOCATOR
TO END PUSH EXIT
2
Press the Number 2 button to select VCR SET UP.
TO SELECT PUSH NO. SHOWN
1 SET REPEAT PLAY (OFF)
2 ON SCREEN MODE
3 LANGUAGE
4 SET VCR PLUS+ CH
5 SET CABLE BOX
6 SET DSS RECEIVER
7 AUDIO OUT
8 VIDEO STABILIZER (OFF)
TO END PUSH EXIT
3
Press the Number 1 button so that (ON) appears to the
right of SET REPEAT PLAY.
Each time you press the Number 1 button, you turn SET REPEAT
PLAY ON or OFF.
4
Press the EXIT/STATUS button. Now, when a tape has fin-
ished playing, the VCR will rewind it and start playback again. This
will happen until the tape has played 20 times. The PLAY light on
the display panel will flash during tape playback and while rewind-
ing. TV programming will appear while the tape is rewinding.
CBL/DSS VCR
EJECT POWER
VOL CHANNEL
F.ADV
PAUSE/STILL
PLAY
REW
VCR PLUS+
/ENTER
4
STOP
EXIT/STATUS MENU
3
1 2
4 5
7 8
100 0
REC /OTR
INDEX
...
VAR. SLOW
TRACKING
SPEED VCR/TV SLOW
REMOTE LOCATOR
Helpful Hints
• The VCR will stay in Repeat Play
mode until you cancel Repeat Play
mode. To do this, follow steps 1 - 2
above. At step 3, press the Number
1 button so that (OFF) appears to
the right of SET REPEAT PLAY.
Press the EXIT/STATUS button to
exit.
• The tape counter memory will not
operate when the VCR is in Repeat
Play mode.
1
TV
MUTE
FF
LIGHT
CLEAR
2
3
6
9
GO-TO
MEMORY
SKIP
SEARCH