Slide Switch - Toshiba TCB-AX21UL Installation Manual

Wireless remote controller kit Installation Manual
8 HOW TO SET THE ADDRESS SWITCH
• When the multiple Signal receiving units are installed in the same room, an address can
be set to prevent cross communication.
• When replacing the battery and pushing ACL button, the address of the remote controller
becomes [ALL] and the Signal receiving unit is enabled to receive signal regardless of
setting of address switch of the operation section.
• For selecting of the remote controller address, refer to Owner's Manual.
• Change the address of the Signal receiving unit by removing screws of P.C. board cover
of the Signal receiving unit. After then, fix the cover with screws using a clamp.
Address Address
l ,
2
Display of remote
controller address
Screw
Address
Ri t
LL
Address switch position
of Signal receiving unit
Address
S
Address switch
of Signal
receiving unit
can be set any
position.
123 ]23
.......... 45_ 4:_6":---_ ....
The address switch is inside the cover of Signal receiving
unit.
Contact the dealer for setting of the switch.
Turn the (_) switch to left for 1,2 and 3, and right for 4, 5
and 6.
SLIDE SWITCH
9
4 5 6_(_)
Face plate
Remove
• Check the slide switch in the battery box of the remote controller is set to [S] / [A] as factory
default.
Select of louver indication set to S.
Select of operation mode set to A.
Slide
switch I
position [_
-11-