Monitor Function Of Remote Controller Switch - Toshiba RAV-GM901KRTP Series Service Manual

10-6. Monitor Function of Remote Controller Switch

n Calling of sensor temperature display
<Contents>
Each data of the remote controller, indoor unit and outdoor unit can be understood by calling the service
monitor mode from the remote controller.
<Procedure>
1
CL
Push TEST + buttons simultaneously for 4 seconds to
call the service monitor mode.
The service monitor goes on, the master indoor unit No. is
displayed at first and then the temperature of CODE No.
is displayed.
2
Push temperature set
the CODE No. of data to be monitored.
The CODE No. list is shown below.
CODE No.
Room temperature under control ∗1
00
01 Room temperature
(Remote controller)
02 Indoor suction temperature (TA)
03 Indoor heat exchanger (Coil)
temperature (TCJ)
04 Indoor heat exchanger (Coil)
temperature (TC)
3
Push button to select the indoor unit to be monitored.
U NIT L OU VE R
Each data of the indoor unit and its outdoor units can be monitored.
4
Pushing TE ST button returns the status to the usual display.
ò
TEMP. buttons and then change
Data name
ò
ò
2
<Operation procedure>
1
CODE No.
60 Outdoor heat exchanger (Coil) temperature (TE)
61 Outside temperature (TO)
62 Compressor discharge temperature (TD)
63 Compressor suction temperature (TS)
65 Heat sink temperature (TH)
∗1 Header indoor unit only under group control.
- 71 -
TEMP. O N / O F F
TIMER S E T FAN M O D E
TIME SAVE A A VENT
FILTER L L
RE S E T TE ST S E T CL S WIN G/ FI X U NI T LOUVER T
4 1 3
2 3 4
Returned to usual display
Data name