Toshiba TCB-AX21UL Installation Manual page 9

Wireless remote controller kit Installation Manual
5
HOW TO PERFORM CABLING OF THE
SIGNAL RECEIVING UNIT
• Flush Mounting
Connection diagram
Indoor unit remote
controller terminal
board
/
Wire of Signal receiving J
unit (Field procurement)
(AWG20 (0.5 mm2))
(UL wires rated 300 V)
Signal receiving unit
Power wire from
Signal receiving unit
Connector
Provided wire joint (WHT 2)
1. Strip the insulation to approximately 0.55" (14 mm) from the ends of the wires to be connected.
2. Twist together the 2 wires and create a crimp connection at the wire joint.
3. If a special crimping tool is not used, or if the connection is soldered, insulate the wires using
insulation tape.
Wire of Signal
receiving unit
(Field procurement)
Power wire from _
_
Signal receiving Wire joint
unit (provided)
• Exposed Mounting
Connection diagram
Indoor unit remote
controller terminal
board
Signal receiving unit
/
Remote controller cord (optional)
- 8 - 8-EN