Toshiba TCB-ACREDU1-E Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Redundancy-Box

TCB-ACREDU1-E

AIR-COND Klimaanlagen-Handelsgesellschaft m.b.H.

Haushamer Straße 2

A-8054 Graz-Seiersberg

www.air-cond.com

Table of Contents

Summary of Contents for Toshiba TCB-ACREDU1-E

Page 1 Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box Redundancy-Box TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E TCB-ACREDU1-E...
Page 2 VERSION E TOSHIBA...
Page 3: Table Of Contents
............TOSHIBA...
Page 4: Safety Instructions
Commissioning and operation of a unit / system may only be performed by quali ed personnel. Quali ed personnel within the meaning of the safety notices of this documentation are persons who are authorized to take equipment, systems and circuits in accordance with established safety procedures in commission, ground and label. TOSHIBA...
Page 5: Five Safety Rules For Work In And On Electrical Installations
4. The earth and short circuit is greater than 1 kV mandatory only on systems with a nominal voltage. In this case always rst the earth and then connect with the short-circuited active parts. 5. To avoid to touch inadvertently adjacent live parts during work, these parts have to be covered and safeguarded. TOSHIBA...
Page 6: Identification
Identi cation Unit designation The Toshiba Redundancy Box TCB-ACREDU1-E is a compact control unit and is shipped as a unit. Nameplate TOSHIBA...
Page 7: Product Description
Product description Application The Toshiba Redundancy Box TCB-ACREDU1-E enables a trouble-free and operating hours dependent changeover of two indoor units. Once one of the two indoor units has a fault, the second indoor unit is switched on immediately. With a temperature sensor the room temperature is monitored on the speci ed setpoint via a two-step control.
Page 8: Technical Specifications
Tightening torque: 0.5 Nm to 0.6 Nm to the relay outputs Q3 & Q4. • 1,5 mm Feed (1;2;PE) Spring-loaded • 1,5 mm Enable contact externally (1;2) Spring-loaded • Q3/Q4 1,5 mm Operation / Fault (1;2) Screw TOSHIBA...
Page 9: Installation
Both lines are marked as follows: U1 stands for unit 1 and U2 is for unit 2. The connectors are plugged into the motherboard on contact CN61 and the shielding line is attached on the unit. Dimensions Dimensions (mm) TOSHIBA...
Page 10: Commissioning
Commissioning Commissioning should be done only by quali ed personnel (Toshiba and Distributors). Installation and functional check Make sure that all electrical connections are in order before you take your Redundancy box in operation: • Visual inspection of connections •...
Page 11: Maintenance
Defective parts must be replaced by quali ed personnel in compliance with the applicab- le safety regulations. CAUTION All maintenance and inspection work on the Redundancy box may only be carried out by quali ed and trained personnel in compliance with the statutory safety regulations. TOSHIBA I 11...
Page 12: Operation
It is a monochrome display with 6 lines and 16 characters per line. The backlight can be shown in three colors (white, orange and red). Cursor CAUTION Do not use any pointed or sharp objects to operate, so that the plastic surface of the control is not damaged. 12 I TOSHIBA...
Page 13: Password Level
After completion of the administrative work it is necessary to log out again. WEB access: User level User name Password Authorizations Admin Administrator All permissions Registration via LAN and a standard web browser at the default IP address: http://192.168.0.1 at a remote access should the port: 8080 be approved. TOSHIBA I 13...
Page 14: To Switch From Operator To Administrator
4. Take over "": Click OK to con rm. The display appears as follows: ADMIN-Password 5. Pressing cursor keys to navigate through the alphabet and select letters: current Password= AIRCOND 6. Con rm password: Button OK The control switches now to access level "Administrator" and returns to the main menu. 14 I TOSHIBA...
Page 15: To Switch From Administrator To Operator
3. Move cursor to ''": Cursor button UP or DOWN Message con g   Home screen Clock   Menu language  Swith to OP  4. Take over"": Button OK The control switches now to access level "operator" and returns to main menu. TOSHIBA I 15...
Page 16: Start Screen
This page is without control panels. FAULT OFF: Unit is switched o RUN: Unit in operation STATUS OK: Unit has no errors STATUS FAULT: Unit has an error (light blinks red) 16 I TOSHIBA...
Page 17: Operation Hours Switchover
8.7. Function Current On/O temperature ON and OFF Setpoints Temperature at which the unit 2 is turned on OFF: Temperature at which the unit 2 is turned o TOSHIBA I 17...
Page 18: Temperature Alarm
The reset of the operating hours takes place in this image. Air conditioning unit U1 and U2 can be opera- ted separately. After a reset, the counter value is set to "0" and the operation hour counting begins anew. The procedure to carry out changes, has been described in section 8.7. Hours Function On/O 18 I TOSHIBA...
Page 19: Sensor Monitoring
The temperature sensor PT100 is, once it is activated by the function 8.7 and 8.10, monitored against short circuit and wire break. The alarm is displayed in the alarm box. At fault both contacts (Q3, Q4) ash, each with 1 Hz. TOSHIBA I 19...
Page 20: Configuring Network Settings
6. The display shows only the default IP address of your controller. To change the setting, press OK. When the cursor appears as a ashing solid square, move it using the arrow keys up or down to modify the number. To con rm your changes, press OK. 20 I TOSHIBA...
Page 21 To change the setting, press OK. When the cursor appears as a ashing solid square, move it with the up and down arrow button on the position of the number to be changed and to increase or decrease them. To con rm your changes, press OK. TOSHIBA I 21...
Page 22: Web Access
2. Enter the IP address of your controller in the IP Address Bar. – LAN access (Local Area Network) via: 192.168.0.1 – Remote access via: 192.168.0.1:8080 Note: Make sure that TCP-Port 8080 is selected for remote access. 22 I TOSHIBA...
Page 23: View System Information
Due to the memory load, this may also a ect the performance of the associated base module. 8.15 View system information Once logged in, the web server displays all the system information of your base module such as module generation, module type, rmware (FW) version, IP address and module status. TOSHIBA I 23...
Page 24: Use Web Server
2. Enter the new assignment address in the added blank column „ “. The symbol indicates that the variable is to be changed. The symbol indicates that the variable is not changed.  Click or tap „ “ to apply the new mapping addresses. 24 I TOSHIBA...
Page 25: Menu Navigation
8.18 Menu navigation TOSHIBA I 25...
Page 26 26 I TOSHIBA...
Page 27: Circuit Diagram
8.19 Circuit diagram TOSHIBA I 27...
Page 28: Declaration Of Conformity
8.20 Declaration of conformity 28 I TOSHIBA...
Page 29: Change History
Rudolf Bayer 29.10.2015 - Updated network, WEB and contents. AIR-COND Rudolf Bayer 16.11.2015 - Updated navigation menu. AIR-COND Rudolf Bayer 15.12.2015 - Software update to version 1.3 AIR-COND Rudolf Bayer 17.02.2016 - Software update to version 1.4 AIR-COND TOSHIBA I 29...
Page 30 30 I TOSHIBA...
Page 31 TOSHIBA I 31...
Page 32 AIR-COND Klimaanlagen-Handelsgesellschaft m.b.H. Haushamer Straße 2 A-8054 Graz-Seiersberg www.air-cond.com...

Toshiba TCB-ACREDU1-E Manual

2 Safety Instructions

3 Identification

4 Product Description

Technical Specifications

6 Commissioning

7 Maintenance

8 Operation

9 Change History

Quick Links

Summary of Contents for Toshiba TCB-ACREDU1-E

Page 3: Table Of Contents

Page 4: Safety Instructions

Page 5: Five Safety Rules For Work In And On Electrical Installations

Page 6: Identification

Page 7: Product Description

Page 8: Technical Specifications

Page 9: Installation

Page 10: Commissioning

Page 11: Maintenance

Page 12: Operation

Page 13: Password Level

Page 14: To Switch From Operator To Administrator

Page 15: To Switch From Administrator To Operator

Page 16: Start Screen

Page 17: Operation Hours Switchover

Page 18: Temperature Alarm

Page 19: Sensor Monitoring

Page 20: Configuring Network Settings

Page 22: Web Access

Page 23: View System Information

Page 24: Use Web Server

Page 25: Menu Navigation

Page 27: Circuit Diagram

Page 28: Declaration Of Conformity

Page 29: Change History

Toshiba TCB-ACREDU1-E Manual

2 Safety Instructions

3 Identification

4 Product Description

Technical Specifications

6 Commissioning

7 Maintenance

8 Operation

9 Change History

Quick Links

Related Manuals for Toshiba TCB-ACREDU1-E

Summary of Contents for Toshiba TCB-ACREDU1-E

Table of Contents