GE JTP16 Use And Care Manual page 34

PROBLEM
"F-" AND A NuMBER
FLASH IN THE DISPLAY
OVEN WILL NOT WORK
OVEN LIGHT
DOES NOT WORK
FOOD DOES NOT
BROIL PROPERLY
FOOD DOES NOT ROAST
OR BAKE PROPERLY
OVEN WILL NOT
SELF-CLEAN
DOOR WILJ. NOT OPEN
CONTROL SIGNALS AFTER
ENTERING COOK TIME
OR STOP TIME
OVEN TEMPERATURE
TOO HOT OR TOO COLD
"BURNING" OR "OILY"
ODOR EMITTING FROM
OVEN WHEN TURNED ON
STRONG ODOR
OVEN NOT CLEAN
AFTER CLEAN CYCLE
"door" APPEARS
IN THE DISPLAY
FAN NOISE
If you need more help...
GE Answer Center@
toll free:
34
QUESTIONS?
USE THIS PROBLEM SOLVER
POSSIBLE CAUSE
This is function error code. Press the CLEARfOFF pad. Allow the oven to cool
one hour. Place the oven back into operation. If function error occurs again,
disconnect power to the oven and call for service.
The circuit breaker in your house has been tripped, or a fuse has been blown.
The oven controls are not properly set.
The light bulb is loose or defective. Tighten or replace.
The switch operating the oven light is broken. Call for service.
Oven controls not set properly. See the Broiling section.
Improper shelf position being used. See the Broiling Guide.
Food is being cooked on a hot pan.
Low voltage. See the Broiling section.
Aluminum foil used on the broiler pan and grid has not been fitted properly
and slit as recommended.
Oven controls not set properly. See the Baking or Roasting section.
Shelf position is incorrect. See the Roasting or Baking section.
Incorrect cookware or cookware of improper size is being used.
Oven thermostat needs adjustment. See the Adjust the Oven Thermostat—
Oven temperature is too high to set self-clean operation.
Allow the oven to cool to room temperature and reset the controls.
door can be opened.
This is reminding you to enter a bake temperature.
This is normal in a new oven and will disappear in time. To speed the process,
set a self-clean cycle for a minimum of 3 hours. See the Operating the Self-
Cleaning Oven section.
An odor from the insulation around the inside of the oven is normal for the
first few times the oven is used. This is temporary.
Oven controls not set properly. See the Operating the Self-Cleaning Oven section.
Heavily soiled ovens require 3 Y?-to 4-hour Clean Time.
Heavy spillovers should be cleaned up before starting clean cycle.
Door is still locked and you are trying to enter an oven cooking operation.
and the fan may continue to run even after the oven is off.
800.626.2000
consumer information service
—