GE JTP16 Use And Care Manual page 29

w to Set Oven for Cleaning
Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
set the cycle.
1. Follow the directions in the Before a Clean Cycle
section,
2. After closing the door, press the
AUTO
AUTO SELF CLEAN pad.
SELF
CLEAN
3. Press the INCREASE or
DECREASE pad until the
desired Clean Time is displayed.
+
Clean
time between 2 and 4 hours, depending
—
on the amount of soil in your oven.
To Stop a Clean Cycle
1. Press the CLEAWOFF pad.
The self-clean cycle will automatically begin after
"CLEAN" is displayed and the time for the clean
cycle is set. The words "ON" and "LOCK" will
appear in the display when the door automatically
locks. It will not be possible to open the oven door
until the temperature drops below the lock
temperature and the LOCK light goes off.
4. When the LOCK light is off, open the door.
NOTE:
You can find out when the clean
will be finished by pressin&
STOP
the STOP TIME pad.
TIME
The word "door" will be displayed, the word
"LOCK" will flash and oven control will signal
if you set the clean cycle and forget to close the
oven door.
A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
continue to run after the oven is turned off.
2. When the LOCK light goes off and the oven
has cooled below the locking temperature, open
the door.
29