GE JTP16 Use And Care Manual page 28

Before a Clean Cycle
The oven must be completely cool in order to set
the self-clean cycle.
1. Remove the broiler pan, broiler grid. all cookware
and any aluminum
withstand the high cleaning temperatures.
NOTE: The oven shelves and the convection
roasting rack may be cleaned in the self-cleaning
oven. However, they will darken, lose their luster
and become hard to slide.
2. Wipe up any spillovers, residue or ash. Gently lift
the bake element to wipe up the oven floor. Both
the bake and broil elements are cleaned in the self-
clean cycle. If you use soap to wipe up any excess,
rinse thoroughly to prevent staining during the
clean cycle.
Area
outside the
gasket
28
Normal Cleaning Time: 3 hours
Oven
light
Area
Oven door
inside the
gasket
3. Clean spatters or soil on the oven front frame and
the oven door outside the gasket with a dampened
cloth. The oven front frame and the oven door
outside the gasket do not get cleaned by the self-
clean cycle. On these areas, use detergent and hot
water or a soap-filled steel wool pad. Rinse well
with a vinegar and water solution. This will help
prevent a brown residue from forming when the
oven is heated. Buff these areas with a dry cloth.
soap and water. Also use soap and water to clean
under the oven vent grille. Do not use abrasives
or oven cleaners.
Make sure the oven light bulb cover is in place.
Do not rub or clean the door gasket—
extremely low resistance to abrasion. An intact
energy-efficient oven operation and good baking
results. If you notice the gasket becoming worn,
frayed or damaged in any way or if it has become
displaced on the door, you should have it replaced.
Close the oven door and make sure the oven
light is off. If the oven light is not turned off,
the life of the bulb will be shortened or it may
burn out immediately. The door latches
automatically after the clean cycle is set.
Do not use commercial oven cleaners or oven
protectors in or near the self-cleaning oven.
A combination of any of these products plus the
high clean-cycle temperature may damage the
porcelain finish of the oven.