HP 5900 Series Configuration Manual page 147

Figure 35 Network diagram
Master
uplink device
Vlan-int3
1.1.1.2/24
Vlan-int3
1.1.1.1/24
Switch A
Master
192.168.0.101/24
Configuration procedure
1. Create VLANs and assign ports to them. Configure the IP address of each VLAN interface as
shown in
2. Configure Switch A:
# Configure the source address of BFD echo packets as 10.10.10.10.
<SwitchA> system-view
[SwitchA] bfd echo-source-ip 10.10.10.10
# Create track entry 1 for the BFD session to verify the reachability of the uplink device (1.1.1.2 ).
[SwitchA] track 1 bfd echo interface vlan-interface 3 remote ip 1.1.1.2 local ip
1.1.1.1
# Create VRRP group 1, and configure the virtual IP address of the group as 192.168.0.10.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 192.168.0.10
# Set the priority of Switch A in VRRP group 1 to 110.
[SwitchA-Vlan-interface2] vrrp vrid 1 priority 110
# Associate VRRP group 1 with track entry 1 and decrease the router priority by 20 when the state
of track entry 1 changes to negative.
[SwitchA-Vlan-interface2] vrrp vrid 1 track 1 reduced 20
[SwitchA-Vlan-interface2] return
3. On Switch B, create VRRP group 1, and configure the virtual IP address of the group as
192.168.0.10.
<SwitchB> system-view
[SwitchB] interface vlan-interface 2
Internet
Uplink
Virtual router
Virtual IP address:
192.168.0.10
Vlan-int2
Figure 35. (Details not shown.)
Backup
uplink device
Uplink
Switch B
Backup
Vlan-int2
192.168.0.102/24
L2 switch
BFD probe packets
VRRP packets
141