Skoda roomster Owner's Manual page 257

256 Fuses and light bulbs
– For vehicles with petrol engines remove the activated char-
coal filter system before replacing the bulb in the right front
⇒ page 255, fig.
headlight
Positions of the light bulbs in the front headlight
A
- low beam and main beam
A
A
- parking lights
B
A
- Turn signal light (at the front)
C
Switching on the low beam and main beam
– Open the bonnet.
– Remove the protective cap
184.
⇒ page 255, fig.
183.
Fig. 185 Removing the
light bulb for the low
beam and main beam
light
A ⇒ page 255, fig.
183.
A
– For headlights with module (halogen lamp H7),
the connector with the halogen lamp to the left up to the stop
and remove.
– For headlights with reflector (halogen lamp H47) pull off the
connector from the lamp, release the sprung wire clamp and
pull out the halogen lamp towards the rear.
– Replace the halogen lamp H7, insert the connector with the
new halogen lamp and turn to the right up to the stop.
– Replace the halogen lamp H4, insert into the opening in the
reflector (with the fixing lugs in the recesses), secure with the
sprung wire clamp, position the protective cap and mount the
connector.
– We recommend that you have the headlight setting checked
by a Skoda Service Partner after replacing the light bulb.
Turn signal light (at the front)
– Open the bonnet.
A
– Turn the lamp holder to the left
C
remove the lamp holder with the light bulb.
– Replace the defective light bulb.
– Insert the lamp holder with light bulb into the headlight. Secure
the lamp holder by turning it to the right until it locks in place.
⇒ fig. 185
turn
⇒ page 255, fig. 183
and