Skoda roomster Owner's Manual page 102

A A
The controls and
A C
The blower should aways be on to prevent the windows from misting up.
Note
•
The whole heat output will be needed to unfrost the windscreen and
side windows. No warm air will be fed to the footwell. This can lead to
restriction of the heating comfort.
•
The used air streams out through the air removal openings in the
luggage compartment.
•
If the cooling system has not been switched on for a lengthy period,
odours may be produced at the evaporator because of deposits. Switch
the air conditioning system on at least once a month for approximately 5
minutes at the highest blower stage - also during the cold season of the
year - in order to remove such odours. Also open a window for a short
time.
•
Please refer to the information regarding recirculated air mode
⇒ page 102.
•
Have the air conditioning system cleaned by a specialist workshop.
Set Climatic
Recommended settings of Climatic controls for the respective operating
modes:
Defrosting the windscreen and side windows
•
A
Put the control dial
A
as usual by you (we recommend 22 °C)
•
A
Blower switch in position 3 or 4
B
•
Turn the air distribution control
Using the system Safety
can be set to any desired intermediate position.
⇒ page 100, fig. 94
to the temperature selected
A
into the position 
C
Driving Tips
Heating and air conditioning system
•
⇒ page 103, fig. 95
Open air outlet vents 4
window.
Keeping windscreen and side windows demisted
We recommend that you use the following setting in cases where the
windows are misted up more than usual (e.g. when it is raining):
•
A
Blower switch in position 2
B
•
Turn the air distribution control
•
⇒ page 103, fig. 95
Open air outlet vents 4
window.
•
Switch on the cooling system by pressing button
Warming up the inside of the vehicle as rapidly as possible
•
A
Control dial at the desired heat temperature
A
•
A
Blower switch in position 3
B
•
Turn the air distribution control
•
Open the air outlet vents 4
•
We recommend that you briefly switch on the recirculated air mode
with the pushbutton . The windows can steam up in this position

however.
Heating the vehicle to a comfortable temperature
We recommend the following setting once the windows are no longer
misted up and the desired temperature has been reached:
•
A
Control dial at the desired heat temperature
A
•
A
Blower switch in position 2
B
•
Turn the air distribution control
•
Open the air outlet vents 4
•
Set the air distribution regulator

and , if the windscreen gets misted up again.
General Maintenance Breakdown assistance
and point towards the side
A 
into the position between and
C
and point towards the side
.
AC
A
into the position 
C
A
into the position between  and
C
A
as required between positions
C
Technical Data
101


