Table of Contents
Advertisement
USB DEVICE SETTING:
The options for these items are found in its sub menu. By pressing the
<ENTER> key, you are prompt to enter the sub menu of the detailed options
as shown below:
USB 1.0 Controller
USB 2.0 Controller
USB Keyboard Function
USB Storage Function
*** USB Mass Storage Device Boot
JetFlashTS4GJFV20 0.00
↑↓→←:Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values
Descriptions on each item above are as follows:
1. USB 1.0 CONTROLLER
This should be enabled if your system has a USB installed on the
system board and you want to use it. Even when so equipped, if you
add a higher performance controller, you will need to disable this
feature.
2. USB 2.0 CONTROLLER
Enable the USB 2.0 controller.
3. USB KEYBOARD FUNCTION
Select Enabled if your system contains a Universal Serial Bus (USB)
controller and you have a USB keyboard.
4. USB STORAGE FUNCTION
Enable the USB Storage Function
5. USB MASS STORAGE DEVICE BOOT
[Auto]: According to contents of USB MSD decide boot up type
[FDD Mode]: The USB MSD always boot up as floppy disk
'[HDD Mode]: The USB MSD always boot up as hard disk.
ONBOARD LAN 2 CONTROLLER:
Enable the LAN controller.
PSB-701LF USER
Phoenix – Award CMOS Setup Utility
F6:Fail-Safe Defaults
'
S MANUAL
Chapter 4 Award BIOS Setup
Onboard Device
[Enabled]
[Enabled]
[Enabled]
[Enabled]
Setting ***
[Auto mode]
F7:Optimized Defaults
Item Help
Menu Level ►
[Enable] or [Disable]
Universal Host
Controller
Interfacefor Universal
Serial Bus.
Page: 4-15
Advertisement
Table of Contents
