Note:
If you change VLAN settings, you need to reboot HG520.
3.3.4 ACL
Click ACL of Advanced in the navigation bar to display the ACL
configuration page. Access control list is used to allow or deny the
access from one or more specific IP addresses in LAN and WAN.
The access control list configuration page is as shown in Figure
3-19.
If you set LAN Enable to enabled, HG520 will only allow the
computers whose IP address is included in the access control list to
access Internet. By default, it is Disabled, all the LAN IP addresses
can access Internet.
If you set WAN Enable to enabled, HG520 will only allow the
computers whose IP address is included in the access control list to
Figure 3-19 Access control list
Huawei Technologies Proprietary
32